Recent content by bigdek

Unvented

Customer wants an UNvented cylinder in place of existing vented. Currently has a dragon RF cylinder stat. No easy way to hard wire the new dual stat supplied with the cylinder. Is a dual RF thermostat available ? Cheers.

randomly tripping even with all appliances unplugged

have a poss faulty one of these and seem quite rare to buy is there a better quality brand direct replacement available http://www.harbordelectrical.co.uk/images/source/Fuses_Breakers/Proteus/Proteus_RCD_100-2-30_100A_30mA_-1.jpg

need french doors fitting, brother and law does this for a living and has let me down badly. dont like the quotes i have been getting so thinking about diy . cutting down existing window which is not a prob. what do i use to close the cavity and what is the exact position for the...

are building regs online anwhere so i can see what regulation 4.4 is ?

submitted my drawings and finally heard from the LA yesterday few things to add to ammended drawings and i need some assistance again. this is verbatim from the letter 1. Fire. confirm method of closing cavity 2 . Environment . show position of vertical and horizontal damp...

because the nearest one is 30 odd miles from me :shock:

need to replace a bit of cast down pipe(rainwater) where can i buy this other than drainage center i assume the sizes 65mm and 75mm are od sizes

existing window getting cut down for french door so lintel ok being fitted my brother in law who does it for a living. existing cavity wall is 300mm thanks for your help

i need o brick up my existing kitchen door to the outside and install french doors in the living room. spoke to council and they say i need a building warrant . i have done the drawings and they say the drawings are ok but i need o write on them the method of how the door will be bricked...

need to get an approx cost for a 6m x 7m garage floor. what the current approx price for a cubic meter of ready mixed ?

i would if it was on the ground floor

do you have a pic. i hate asking for stuff that i dont know what it looks like.

many thanks i'll get on the case tomorrow