Recent content by chuckle bros

Only happens on passenger side. Driver side fine. hazards work fine , it's only when you put left flashers on, it has the fault. Sometimes it's fine then every few seconds it races then back to normal No bulbs out.

My vauhall mariva has a fault on the nearside indcator. Sometimes it flashes super quick, works fine when hazards are On. No bulbs out. I think it's the relay (nightmare to get to to replace ). I'm struggling for time to replace it before MOT. Would it fail on this.

Thanks. Should I run the engine after I refill, until the fan kicks in, and should I leave the top off the expansion tank to let air out, or is that not necessary. Again thanks.

What is the best way to empty a radiator. I have a vauxhall Mariva 04. The anti freeze is a bit manky looking and needs replaced. What's the best way, remove pipe and drain or as the Internet says open the bleed valve. If it's the bleed valve where is it?. I'm a builder not a mechanic. Any...

cheers. when weather picks up i will tackle it. looks like i need to be Mr tickle to get to it. and a root around my tool box for a torx bit for my stumpy. again cheers Dave.

vauxhall meriva. When left indicators are on every few seconds they go twice as fast, then back to norm. I've replaced a tail tight and a number plate light that were out. still have same issue, may not be related. Only happens on left. no indicator bulb is out. works fine when hazards...

I removed 3 storage heater, removing the bricks 1st before taking them off the wall, is it posible to replace the switches on wall with a single socket?. Or will i have to use blanks . [/code]

I wish to extend the cable on my pond pump and filter, whats the best way to do it.

If you want nice sharp angles on your render use stainless steal angle beads, galvanized beads react with cement and will rust. Use a lot of PVA on the blocks before rendering unibond or similar. I would not render straight to ground level leave a gap by using an angle bead. Once done coat with...

Great thanks. So i will fit the shower do the plumbing and get a part p to run the cable in himself so he can verify its 10.5mm and he knows its installed correct and can notify the local authority. Sounds the best way, keeps him right and me right. Cheers guys.

Is it allowed under the new regs, for me to fit my own shower in stall all the pipe work fit the shower unit and run the cable to the consumer unit but get a sparky to wired it to the fuse. I'm a builder who is now to ill to work so wondering what im allowed to do myself to keep the costs down...

Im going to put a new fence up, about 6 foot. Its on concrete, im thinking about using the post holders as i dont want to smash up the concrete and sink the post in. What sort of expansion bolts should i use and what size. Any help as ive never built a fence this way i normally use postcrete.

They come with a 10 year anti rot guarantee, but i always re-treat when i get them. And treat every year.

I've used Screw fix's own brand water seal and Thompsons. Ive not noticed any difference in the products.

Water seal is still your best option, you could get away with leaving it for a few years between coats, if your timber is pressure treated which it should be, this plus a good water seal treatment your shed will out last you. It only takes about a half hour to do,