Recent content by Danny_P_G

Hi, I changed the towel radiator in the bathroom like for like as the old one was looking old rusty ect ect . I turned off both bottom valves im removed it and put the new rad to the old pipe work . First question do i just open the top bleed / vent and open up both valves and wait till...

Hi Guys , Can someone help or advise me I work in a workshop that has asbestos roof panels that i know are fine if they stay in that condition , but today for no reason small chunk fell off and looking at the roof its cracked all over its full of water marks and leaks and in a very bad...

Tried to start this morning but nothing happend . it kept turning over but would not fire up . Im going to have a look at it in a bit , and suggestions where / what to check first It was petrol in and it turns over ( so batt not flat ) Cheers Guys

Tried to start this morning but nothing happend . it kept turning over but would not fire up . Im going to have a look at it in a bit , and suggestions where / what to check first It was petrol in and it turns over ( so batt not flat ) Cheers Guys

Hi, I installed an electric hob and all worked fine when i tested it, about 1 week later 1 of the rings stopped working the other 3 still work fine . When i installed the wire connections i used bridges (3) as per in instructions all worked fine 240 v Any help will be great or is this a...

Thanks guys ! breezer was as much help as a toffee hammer but the rest were a great help

Sorry is was a mini portable compressore that was tested , When we test 110v we need to use the transformer .

Hi , I have just started to do our pat testing at work the guy who does it is training me . Does anyone have have any info they can send me or download ie Training so i can learn more . Also when we were doing a pat test on a 110 v compressor during the run test it kept tripping the 110v...

Hi all It has came on out of the blue . 51 Plate 1.3 petrol Its not flashing or anything in the book it says malfunction go to your ford dealer asap . Is there a reset button as im sure there is nothing wrong with it , it was fine last week when i drove it but started it up tonight...

I pulled an old engine out the skip at work and got it working fine ! its a lawn mover engine 4 stroke . Can anyone help me think what i can do with it apart from putting it back in a lawn mover or is this the only use for it ? Thanks chaps

Thanks , i will use the copper tails for better support . cheers

Hi, I am going to take out my old taps and fit a new mixer tap in the kitchen ( well im fitting a new kitchen ) On the new tap it came with 2 copper reducing pipes ( 15mm to 1/4 bsp with o ring seal ( i think ) ) one to connect to the hot and 1 to the cold water supply. I am going to...

Yes 1 x transformer for all 3 light ( been in loft and had a look )

Hi. Im my kitchen i have 3 spot lights and one old strip light and all work off the same lights swich ! Sometimes when the lights are on the 3 spot lights go off for about 30 seconds and then come back on, the strip light stay on all the time ! Im not to clued up on Electrics but if anyone...

Hi I have got a gap of 440 mm with out the bottom bit that goes on . Do you think this will be ok as i need this height as i dont want to drill through the wall if i make them higher ??? Thanks guys