Hiya people,
Great forum you have here and if I am in the wrong section, well many apologies as I am still a bit of a newbie..lol
Just wondering if anyone can throw some light on my little tiling job. Many thanks in advance for an comments made, much appreciated.
I am just about to re...
Thanks guys for your input.
Well, I did assume there was still some damp behind the bottom of the shower room tiles.
I used a bal mould cleaner to remove the damp from the lower half of the shower enclosure six months ago. I then did not use the shower enclosure for six months and kept...
Hi folks,
Many thanks in advance for any advice anyone can give.
My little dilemma is that I believe I have damp in the bathroom walls behind the tiles. I thought I had dried out the walls sufficiently before tiling the bathroom.
I have concluded that using a dehumidifier would get the...
Hi folks,
Many thanks in advance for any advice anyone can give.
My little dilemma is that I believe I have damp in the bathroom walls behind the tiles. I thought I had dried out the walls sufficiently before tiling the bathroom.
I have concluded that using a dehumidifier would get the...
Hi folks,
Many thanks in advance for any advice anyone can give.
My little dilemma is that I believe I have damp in the bathroom walls behind the tiles. I thought I had dried out the walls sufficiently before tiling the bathroom.
I have concluded that using a dehumidifier would get the...
Hello folks,,
Newbie here...can you take a goosies at this..:0)
I have a baxi bermuda back boiler running five radiators
Two small rads, two medium and a large one.Now I have flushed and drained the system, it seems to run well as I am unable to hold onto the bottom of the rads for long...
thats a good point.
I dont know if it has been cut completely until I plug the loop where the hole is.
I guess one I try and make the loop again, I will have a better idea then
The whole did short one metal bracket and blow the 30amp ring main fuse but I have stopped it shorting out now by...
Thanks for the advice lads.
Continuity is o.k. I have a double outlet socket just below the hole (three foot down) so I may go for putting a single socket where the hole is.This will allow me to pull some cable up from below and give me some slack for the new outet.
Many thanks again lads...
Hello folks,
Can anyone advise me of the simplest way to get around a hole drilled in the ring main. The hole spits fire and crackles loudly every hour or so.. :(
Some ideas I had were to
a. Replace the cable completely with another.
b. Put a single outlet socket in where the hole is...