Recent content by garash

To give you some insight I am 72 Female not in good health. I purchased 2 Oak Veneered Doors and after several months found someone at last to Hang them. Ideally if it had been possible I would have preferred to have had these up on a table lying flat to apply the chosen finish before adding...

Thank you all so much she says ! also I did think about having it Freestanding so will take a look at UKBoxings.

I have decided to do this myself as I have been unable to get someone. No negative comments please I am over 70 and have Vertigo and Crooked Fingers so jobs are a struggle. Can anyone advise on how I could attach a box covering to the wall? I am hoping not to have to use Brackets as for me it...

Thank you. I'm quite capable of doing some jobs but don't trust myself to remove the Corners and get it back together! The Top has got to come out so when I get to do the replacement I will post a photo.

Yes I agree

Yes its an outdoor Table. And Nothing. Literally not even a screw anywhere. This takes me to the plastic pieces set into each corner where the Aluminum sides all meet up. This is why I believe the Frame is set around the top itself. Made by Gopak

I have an Aluminium Folding Table. The Top has warped and Buckled. It is made of Hardboard(?). I have attempted to soak it with water at the back, turn over and put a very heavy concrete ornament on the Front. I left it for a week and the result was OK but it has now lifted again. I am thinking...

I have a Worcester Greenstar. This is my first time attempting to Back Fill as the Boiler is 18 mths old. I am able to insert the Key with the arrow to the left under the open lock symbol. I hear the key 'click' in but when I try to turn to the locked position/symbol the Key just keeps turning...

Hi, I think I need a Scientist for this; twice after leaving a tin can on top of my (oiled) Worktops I have been left with a ring mark which I cannot get off. The tins were both clean and dry. What is causing a reaction to the metal to make it do this?

Does the bath need to be removed to get to, remove and replace mixer taps?

Thank you both, and just confirming that it is not water damaged, has never gotten wet so I think it can only be wear but why in uneven places heaven knows!

Thanks, think I shall give Osmo a go !

Thank you all for the info. These worktops were installed April so are quite new and what I have been told by the Company I got them from is that they should only ever be Oiled and not to use any type of varnish. To be honest, given the marks on them already I would of thought using Varnish...

Me again lol ! These pics are of the top of my Sideboard which is Oak. Recommendations please on what I can use to restore it? Hoping to do this with one product as opposed to Staining then having to Varnish. Thanks !

Yes they are Bare wood which I understand have been oiled.