Recent content by Jetheat

I used to have varilight but then I switched to the wifi system Lightwave.

Still flickers at 100%.

Suppose I put a normal switch on and it doesn't flicker. Does that mean that I need to change the switch or the bulbs? The switch is part of a whole smart hub system (Lightwave) so it's not much of an option. JH

Would I need a dimmable switch?

Some unknown brand known as Belns Melns, but they are Amazon's preferred choice.

ok, I ordered some new dimmable GU10 bulbs from Amazon and changed them with what I had. Now I have a different problem. If I set the brightness to 100%, then it flickers every second or so. If I reduce it to 95%, it flickers less often. If I set it to below 90%, it doesn't seem to flicker...

I assume that it is. I'm using a well-known light switch (Lightwave). JH

Ok great, any idea what the issue could be and how I could remedy it? Is it something I can do or would I need an electrician? JH

The flickering wasn't there before.

Forgive my ignorance. What is a starter and where do I find it? I have Spotlights.

I asked an electrician to come and replace my consumer unit and tidy up some wires. He came and replaced it with a fusebox unit. Then, because of a continuity fault somewhere, he checked all the sockets in my kitchen, one by one. Couldn't find the fault. But he tested them for safety and signed...

PLEASE ENGAGE THE SERVICES OF A QUALIFIED ELECTRICIAN

My fused spur feeds about 5 wires into the junction box. So I take it one of them is live and one is neutral, right? i can detect a live wire. How do I detect a neutral? JH

So how will I know which live and which neutral to use for the relay?

Out of all the wires going into and out of the junction box, will there only be one live wire? JH