Hi, I am planning to dry-line an exterior wall in my old house.
Something that is confusing me: there is a bit of a mismatch between the thickness of CLS timber and the rigid insulation board.
3x2" CLS timber is 38mm thick, Kingspan TP10 comes in 30mm and 40mm thicknesses.
I appreciate it's...
Hi all, apologies for the delay, I was waiting for the house to be empty over the Christmas break to play around with it some more and then completely forgot about this!
Secure I AM:
Area A = Entry/Exit
Area B = Instant
I changed Area B to Timed Exit and it armed both areas once the front door...
Hi, my alarm panel has been out of use for a year or so (building work being done) and now I am trying to start using it again. I have two Areas: A = Internal PIRs (and front door), B = Exterior doors. I have a single keypad.
When I try to arm the panel and exit, Area B (part) arms quite...
Thanks everyone for your replies. To answer some of the comments:
Sparkymarka: Yes, you are right, this is arming fail, not a full alarm trigger. But the keypad does make the same noise as a full alarm. Not sure if this triggers the external bells as it is currently switched off. Would you...
Hi, I have Texecom Premier Elite 48 with a niggling problem: if the exit procedure is interrupted, the alarm is triggered immediately.
Relevant info:
3 Areas, A, B & C
The keypad, front door and hallway PIR are all in A
This is how I encounter the problem:
Start the exit procedure
Open the...
Sorry, yes I was also referring to Texbase/Montex.
My problem is that my internet is from Virgin Media and could be easily disabled by cutting the cable via the small service cover on the pavement out the front of my house.
I can already access Wintex via remote desktop and it would appear...
Hi, unfortunately I cannot check it. I was hoping it would work with com-usb (that I have already) but it would appear that I require com-gsm or com-ip (neither of which I have).
I found BDE Administrator in C:\Program Files (x86)\Common Files\Borland Shared\BDE.
I then created a new database, STANDARD, PARADOX and then set the path as you described.
I then loaded Texbase and it seems to be ok.
I'll give it a go and let you know!
Thanks, Kevin
Hi, I have just installed Texbase 2.8 and Montex 2.11 that came on the CD I got with my Com-USB cable.
I am now trying to run Texbase (as administrator) but I get the following error before anything loads:
"Exception EDBEngineError in module Texbase.exe
Unknown Database
Alias: Texbase"...