Hi all, am looking at building a lean to on the side of my house using the existing perimeter wall. The area will be used as a shed/storage area and will have a wood/felt roof. From my perimeter wall there is a 1m gap to the pavement were am currently growing laurels.
Will I need planning...
Firstly am not a plumber or electrician, but I have installed Hive before in my old home quite easily.
I am now in a new Redrow home and have a hot water cylinder which I never had before.
Also I have 2 heating zones, downstairs and upstairs.
So I am looking for help regrading wiring more so...
Cracked it
A = 1
B = 3 correct
The issue was the reciever which actually wasnt sitting properly on the back plate. Due to its position being high it looked as though from the bottom it was fine, when in fact a piece of bent plastic was causing it to sit off frame meaning the connection was...
I've now put the black wire in slot 1 and the yellow wire with the red tape on in slot 3, but still the system isn't working really at a loss with this. Oh ps the timer is set to permanently.
Really grateful to any help with this. It must be noted the thermostat, hub and receiver are all...
Hi I currently have a Honeywell BDR91 receiver and I am replacing in with a Hive receiver, my boiler is an Ideal Independent+.
I have fused socket which goes direct into the boiler and then 4 wires come back out of the boiler and were attached as shown into the BDR91. The Hive is a single...