Hi all,
Finding it a little hard to get my head around something and hoping one of you might be able to help/ advise.
I had some Split Face Quartzite Mosaic Tiles and I want to know a few questions.
I want to seal them as best as possible and have them kinda add a wet/darker look to them that's...
Hey, I did not think it would be but mate I tried everything. I think the one in boiler is just about big enough for the volume of water in system. But not had any pressure drops or spikes. Going to put a larger vessel on it when I sorted this issue out anyway I think.
As for it work yes and no...
Like this picture I have attached. This should still pump water around the system. And show in my opinion the max flow I can achieve with this pump with the flow gauges opened max along with actuators. I still get no flow or hardy any where I have been told this pump is fine for the run length...
Can I just ask a stupid question. When it was all complete with mixer/blender ect. If I turned off the flow and return to the boiler with some lock off valves before the manifold and pump in theory then creating a loop within itself I still get no flow O on the flow pots.
How is this possible...
Hey,
Poor flow around my CH underfloor heating system just installed.
I have changed everything possible and now have manifold direct in to boiler to try and find out what it could be with still no or not much flow to allow the heat to be pushed around.
Thanks
Hey yeah I could try that. the manifold has no restrictions on it.
when I know what the issue is and if it’s boiler side I will get him back. but over last few days we been thinking it was the underfloor manifold side witch he knows little about. But we have changed mixer, pots, manifold pumps...
And no I am not banging 80c around my floor as I don’t have a mixer in testing to fine the route of the issue.
I would love to tho as it would be working with flow lol
Thanks
Yes along with the Plummer it’s been done under gas safety ect. We are not cowboys. I am just trying to eliminate things to fix the issue.
And going from flow of boiler direct to the flow of a underfloor manifold and the return direct back to boiler you can not get any more basic than this. No...
Yes. Think last few messages where for someone else. Does anyone have a ideas tho..? I am gunna take the pump out tomorrow but it showing it’s working fine and tried all boiler pump settings too. thanks
Hey. No work really just a new system. Hot water tank and underfloor.
There open underneath boiler.
I know there is no flow bec the pots on the manifold don’t move. And if I close all 12 down have one open I get the smallest amount of flow. Like less than 0.5lpm. Also boiler goes in to anti...
It is nothing after restricting it as I have Plumbed it in to just the underfloor heating manifold to eliminate eveythi g else. no values no mixer no nothing just flow and return to manifold. So it’s something in the boiler stopping the flow. thanks