Recent content by smudge1946

go here, they seem more helpful and flexable, but there are dead head's on all sites mate, just ignore them, most folk's are helpful. I think below is the right addy if not go to Google. Good luck 8) groups.google.com/group/uk.d-i-y

Thanks for reply, boiler fitted was feb/march so that bit is ok, gas was connected by CORGI engineer and fired up by same, i have been in touch with Ravenheat am awaiting reply. Thank's all again. Smudger :)

Thanks for info. I had a look at flashing kit in B&Q AND THERE ARE NO BITS MISSING AND NO INSTRUCTIONS EITHER. Will get in touch with Raven. All this heating work was finished before April do i still have to have it inspected? :oops: THE GAS WAS CONNECTED BY A CORGI ENGINEER/ PLUMBER.

Thanks Slug, flu fitting was simple, flashing seemed obvious but we had water in when we had some heavy rain, no instructions with it, they must think it was idiot proof, i may have fooled them though!! Was fitted b4 April was that the cut off point for works in progress? regards Smudger

Make sure house insurance is up to date, then set fire to it all LOL! NAIL VARNISH REMOVER HELPS SOMETIMES THOUGH

"finial" OR A CAP OF SOME KIND, IT WILL ALWAYS OPEN AND CLOSE DEPENDING ON TIME OF YEAR BEST OF LUCK

Thanx. Which make and do i fit it on flow or return/ do i have to set pressure on valve or is it pre-set like the old relief valves i used to fit years ago?

yes Spark!

NO 2 both questions, of course there is an isolating pull cord in b/room

no split load, only need an RCD as an additional safety device in instructions, it has an pull cord isolating switch within bathroom of course.

just had an electric shower wired in sparks has put it on an MCB in cu, shouldn't it have an RCD aswell? :?

just had an electric shower wired in sparks has put it on an MCB in :cry: cu, shouldn't it have an RCD aswell?

i need to fit a by-pass to my combi boiler does it have to be an automatic one or 22mm pipe and valves? :shock:

Hi all, I am new to this sit. I fitted a Ravenheat combi boiler earlier this yr and it has been working fine, the other day water came in around the vertical flu flashing and into boiler, sent pic of flashing and flu to b&q thats where i got it from and they said it looks like flashing has...