The wind has just dislodged a great lump of the rendering running along the roof line above the first floor windows on the front of my house, similiar to those in the picture . I need to get it checked in case other pieces are loose and re rendered at some time. I just need be able to use the...
Just bought to fit Kilsviken sink with 28mm hole for overflow ring I need a copper or black fitting of that size but cannot find them anywhere local or on line. They are all to fit standard 23-25mm. Any ideas ?
Just bought and now fitting a Kilsviken sink. No problem there but the overflow hole is 28mm across. I have the chrome fitting they sent with it but that will soon rust. I have been looking for a copper or black fittting in fact anything except chrome but just cannot find any alternative
I...
I have just coated a re claimed pie scaffold board worktop with Osmo Polyx oil 3044 Raw Matt. Great clear whitish finish without the pine turning orange. All the dents, scratches etc filled with epoxy resin.
But still looks bit dull compared to the other worktops in the room which are oak...
https://www.kitchenworktopsonline.co.uk/kitchen-worktop/pitch-pine/ Loads of companies offer pine worktops and kitchen islands and a combination of oak for show and pine for the rustic look worktop round the sink and hob. With resin infills and flooded with Osmo polx oil they last as long as...
I have fitted two oak worktops which look great but for the third being asked £1,400 for 3m length, half of which will be cut away for the hob and sink so settled for pine scaffold boards which are now sanded and ready for oiling.
But still lots of small crack and a few larger saw cuts which...
No I mean a rear vent cooker hood. I can see dozens of top vent hoods and cupboard hoods but only one rear vent one - ElectriQ. There used to be many with combined rear and top vents and you could use one or the other biut I have only seen this one
Mine has packed up after about five years so looking for a new one Small kitchen 2.5 m x 4 m x 2.50m high. I want one reasonably quiet with good extraction as lots of stir frys etc But having problems finding a decent black hood with rear extraction. It seems they are now out of fashion but...
I have never heard of continually oiling the oak 4 times without allow it to dry, just turning and returning until after four coats you finally remove the excess. I have alway allowed the oil to dry between coats so I can accept the four coats but not continually turning wet surfaces so they...
Just taken delivery of an oak worktop. The guy who made it recommends Danish oil for oiling it both side 4 or more times continually without letting it dry. He says that is to get it to soak all the way through. Then wipe off excess and let it dry before another couple of coats, up to four, then...
I have 2 first floor picture window showing bare wood and in the need of painting along with masonry cills. I dont want to hire a scaffold so want it done as quickly and easily as possible from a ladder. I also have a dozen of half tins of paint to use up.
Thinking of washing, scraping...