Hi Thanks for your response. I don't want to increase pressure just hopefully use the pressure that is existing and somehow utilise it via a valve so that it changes speed. May not be possible but hope it is.
Hello,
I have a pneumatic bench top press that I use to press picture hangers into frame backing board. It works really well but in an ideal world I would like to increase the speed of the piston stroke as at the moment overall down and back takes about 5 seconds. I am attaching photos of the...
Hello.
I'm buying a small bench top pneumatic press for my workshop
It comes with a foot pedal to operate it but want to connect a two hand button control so that both buttons have to be pressed together to make sure that both hands are out of the way of danger.
Is it possible to buy these for...
Hello,
We have had an area of external render repaired and I will need to paint it. I have put two coats of stabilizer onto it. Normally I know that it would be necessary to put a diluted first coat of paint on first to soak into the pores but as I have stabilised it is this still necessary...
Hi,
I posted a message regarding how to replace a cable in machine I have . Got some helpful advice. I'm posting this under new heading because I didn't want to confuse the issue and hopefully reach out to more people.
I am going to replace the old cable and fitting on the end with a new one of...
Thanks yep I'll give that a go . Hoped someone might have had experience with those particular ones ?
What I might do actually is cut the old cables halfway and then solder new ones on to them .Saves having to mess about with poking about.
Hi,
I have two brand new button switches
( they are called micro switches on the packet) these both have cables on them that are exactly the same length as the faulty ones. They are like for like. I simply want remove the old buttons from the machine then disconnect the cables from the...
Hi, Thanks for your responses. The micro switches/ push buttons are as mentioned for pushing ( two at the same time ) so that hands are kept safely away from the blades when they come down. The microswitches are not part of the circuit board.
The wires from these trail down and go into the...
Hello,
I have a framing machine that uses two micro switches buttons that have to be pushed at same time to operate. This keeps hands out of way of blades.
They are faulty and I need to replace. I have located where the two wires from each micro switch go and these look like push in connectors ...