My current programmer has lost some lines on the display and does not allow to reprogram it. Otherwise it is working fine according to the pre-existing settings.
Can anyone please guide if this is a matter of a battery change or the whole unit needs replacement.
Is the replacement with a new...
Hi Charnwood,
Thank you for clarifying the matter graphically. It will help those a bit confused....if any.
And what would your input be to the issue raised?
Cheers
Zack
Thanks for the reply Pete.
My F&E tank is in the loft. I also thought its fed thru the mains. But when I closed the mains there was still a powerful inflow. Hence my question.....
So its probably fed from somewhere else despite if I follow the pipes it tees with the inlet pipe for the CWT (...
Two questions please.
1.Where can I buy a new such valve preferable a TVR.
2.Where can I see "how to replace the valve in such radiators.
Any graphical diagram or videos will be appreciated.
Thanks for your help and guidance in advance
Zack...
When I press the 'SET' button I do not see the "CLOCK ?" option coming up.
Also the bottom part of the data on the screen is not visible.
Any suggestions please?
Can this unit be "reset"?
Thanks for your help
Zack
When I press the 'SET' button I do not see the "CLOCK ?" option coming up.
Also the bottom part of the data on the screen is not visible.
Any suggestions please?
Can this unit be "reset"?
Thanks for your help
Zack
My radiator valve is leaking slightly from under the cap.
I tried to unscrew the cap and then reach the nut and tighten it. But the screw holding the cap is rusted and the screw-driver will not hold.
Any advise how to unscrew the cap pleace?
In case I need to replace the whole unit where can...
Meanwhile I bought from B&Q a 10 amp round 3 pin plug and socket.
Would it be safer to connect the flexes mentioned in my initial email thru this connector instead of a cable lead?
In doing so I will be removing one plug ( with a 3 amp fuse) from the way and remaining only with the plug ( with...