Search results

Well I have never done a slate roof where the slates are not on the batten, I don't know the consequences. Should have used slate and a half on the verge. Has he installed soakers on the abutment side, normally ally or code 3 lead.did he mentioned ventilation at eaves or high level or insulation...

Is there a reason why the top of the slates are not on the bottom of the battens?

Will look it up. The reason for it is for safe isolation

Or even unswitched

Think the regs are unstitched socket

Try to cut the lead pipe square, clean the outside of the pipe, you may have to file the pipe down a bit to get lead loc on. Normally 7 or 9lb Probably 7lb

Wishing you all the best Conny

Air seperator

It could be air lock around the cylinder. Post photos of cylinder and pipe work

Manufacturer instructions overide British standard

Undo the screw's

No, do not use the boiler.

Business rate, takes into account the cost of running a business and all associated costs. It's not all profits or wages

Looks like the cylinder temperature and pressure relief valve is connected to the heating system

Room sealed boilers draw air from outside, open flue draw air from inside. Normally any open flued appliance above 7kw will require ventilation from outside

Open flue boiler's are not allowed in bathroom's

Ovia inceptor, Tri colour, ip65 You can adjust to change colour

Yes

A gas pipe behind the plasterboard should also be fully encased in dot and dab. Electric cable should have a minimum of 25mm separation. Check the regulations