Search results

Thanks for the replies. The ceiling wall paper is in a bad way, so didn’t really want to leave it but then again I don’t want stripping the paper to create a problem with the plaster board. Is papering over the top an idea, or will the issues show through too?

Hi. We are doing up a bedroom and wondered what to do with ceiling. There are quite a few cracks in the wallpaper, some examples in the attached pictures. I assume the cracks will also be there when we strip the wallpaper as likely to be cracks in plasterboard?? If so, can we just fill the...

It's been running for a few years now. Wife seemed to think it went very hot the other day and then not been the same since. I've replaced the thermostat but still no life!

Thanks for the replies chaps. There are no mats or rugs - just the floor and it's just not getting warm like it did yesterday. I might try and replace the thermostat and see what that brings!

Hi We've got a heat mat mesh underfloor heating and today noticed it's not getting warm. Normally you can feel floor is warm. Digital thermostat is working and heat is set correctly and shows as heating... but not warming. Room heat shows lower than the set temp. Any ideas on likely cause...

Thanks again. Will have a gander!

Awesome thanks guys, much appreciated - I'll take a look. So this will be a constant dripping into the tank? Where would the washer be?? On the ball value itself?

Hi. I've noticed that the overflow seems to be leaking, but I think it's only happening at night/early morning. Sometimes I go outside first thing (around 7am) and see it dripping. I swear that if I run the hot water for a bit then the dripping stops. Need to test this further, but the floor...

It's an SGS43E08GB/43. It's now got worse however. It keeps on pumping when the lights go out on the front and even when the cycle has finished. HELP!

It starts running and then lights go out and it stops. I then tap the front and it jumps back into action and carries on where it left off. It then may do this a few more times or jsut run to completion. Any ideas on where I need to start looking? Thanks

Hi. I was at home yesterday and the alarm decided to start ringing. I checked the code panel and all looked normal, usual lights were on when the alarm is not set. I tried to enter the code, but that didn't stop it. So I disconnected the battery in the main control box and the alarm stopped, but...

Hi, I've read loads of posts about problems with Suprima boilers and the PCB problem. I've got a boiler that been working fine for the last 4 or so years since I moved into the house. However over the last couple of months it's not been firing up and I've had the press the reset button and then...