Search results

Thanks so I test continuity at these points without the power on?

Where are the brushes on the drill please?

I do yes

Power to here

Power all the way through the drill press the button and nothing.

Would anyone have an idea why this boss 110v drill may have stopped working. I have taken apart to see if was a loose connection but can't notice any thing. I have had a volt stick near it and it picking up power all the way through. Thanks for any help

Was everbuild

It is harder to get a good finish with it? Its not just me. Dow conning etc seems alot thicker

Does anyone else struggle to get a good Finnish with cheap silicones? I usually use dow conning or forever white. But have tried a cheaper one and struggled to get a good Finnish.

Do they do a washing machine tap that will take two appliances without putting one of those V connectors on a single tap. Thanks

Are the telescopic version of this better as you can lower the handle below the bath possibly?

Ok if I bed in on sand and cement I wouldn't be able to panel till the day after. Even if I didn't stand on the tray.

That's the riser option

So run them so they run across the joists not parallel too.

Also is there a way the 4x2s should be layed? I guess across the joists?

Thanks the issue would be it's a tray in the corner of the room so I would need to put two trims on. And likely a bit to cover the corner were the two trims meet. So I would have to remove that to remove the panel.

Is that correct?

Leave the front back about 10mm to stick some plastic on to cover the 4x2. What about leaving it so the trap is accessible without smashing all the panelling off at the bottom. The tray will have two edges open to the room so need panelling

Not an issue as the hole for the threaded bolts doesn't effect the soundness of the tray..

Would be like that