Are the riser kits for shower trays with the threaded bar that screws in to the tray any good?
Not an issue as the hole for the threaded bolts doesn't effect the soundness of the tray..Not an issue ... stone resin with a nice flat base ... I wouldn't even use sand and cement. A good strong base then a good strong adhesive would work fine.
Some only use S&C, some use a flexi tile adhesive, I've used a good strong silicone adhesive when suitable without issue - depends on the warranty too and if that's to be maintained.
Is that correct?Leave the front back about 10mm to stick some plastic on to cover the 4x2. What about leaving it so the trap is accessible without smashing all the panelling off at the bottom. The tray will have two edges open to the room so need panelling
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local