Search results

Hi all Boiler seems to work fine but have noticed on 2 occasions this week that if i put the boiler on not long after turning it off that if i try turn it on again that it wont fire up or takes a few attempts anyone got any ideas.

Hi all the other week i noticed these cracks at the front house under the kitchen window, i have a tree about 4-5 feet away in the garden next door and not sure if it has caused it luckily its owned byt the council so i can go to them to sort out the tree but i am just worried that this maybe an...

Hi all looking to paint my kitchen doors as to buy new doors for my kitchen im looking at £300+ they are pine with an oak stain does anyone know if i can prime and spray and lacquer with normal car paint and if not what should i but i dont want to roller or brush i want a smooth gloss finish.

Hi All I have had a leak in the loft and in turn has damaged the bedroom ceiling i bought a texture roller and artex plaster to repair but it has come out all prickly and a lot smaller than the previous stipple effect can anyone tell me what i need to recreate the same effect [/img]

Hi All I have been hanging some doors over the weekend and one has gone a little wrong and wondered what the best way to fix it would be. Basically one of the doors is not level at the top and although there are no gaps in the door frame around the door one end is a few mm higher than the...

Hi all A couple of my interior doors in my house were damaged when i bought it so i though it would be a good idea to replace them all seeing as i am redecorating and they are quite old however i cannot find any to fit they are about 2030mm long (about 80.25") and 725mm wide (about 28.5") i...

2 months ago i fitted some real engineered oak wood floor there are sufficient expansion gaps all the way roung with the correct underlay under it. However near a door where everyone walks in there is a slight gap between 2 planks only about 1mm anyway it seems that this part of the floor is...

I have a 10mm system downstairs and i have just gone to fit a towel rad upstairs with all my 10mm fitting and found out that some genius has put 8mm piping upstairs does anyone have any suggestions how i can get my 10 mm fittings and pipe to fit to the existing 8mm pipe

I have tried to straighten some microbore that runs into the wall as i need to fit and new outlet TRV to the radiator but where i have stratighened it the bit near the wall has slightly flattened to fit new pipe i would need to knock a small hole in the wall to do so, or is there a way of making...

Hi all I bought an ex council house 3 years back and it only ever had rads downstairs however upstairs in every room there are pipes in a small hole in the wall as if giving the indication to add extra rads. However im not sure what to do as it looks as though the 2 pipes in each room have...

Hi all I laid some real oak flooring with a laquer finish some time ago anyway when going to replace the radiator i dropped it on the floor making a nice a scuff and dent in it does anyone know how i can repair the dent and re lacquer it.

Recently i removed a radiator for some decorating however i notice a damp patch on the wall a few days later and found that the outlet valve on the 10mm microbore piping was seeping slightly so i tightened it and it cured the problem. However today i cam to refit the radiator and as i did so...

Hi all im new here but wondered if anyone could help, i bought an old terrace council house a couple of years ago in peterborough and it has only ever had 3 double radiators downstairs. However upstairs there are little metal plates in 3 bedrooms and the bathroom behind these plates are 2...