Search results

Hmmm, yes, & in all probability it would end up on flea bay, just waiting for a sucker, (me), the alkathene pipe is defiantly cheaper, but I think I would prefer to pay the extra for copper. I think I`ll look for a branded & kitemarked pipe. EDIT. No Bugger it, I will go with the MDPE, I...

Thanks Tony, I did think of blue pipe, but although it initially runs under the floor, it will route up through a false wall & over the dining room & kitchen floors. The pipe I`m looking at has no kitemark or grade.

Hi, I have recently inspected all my pipework & have discovered a section of 15mm copper pipe, in between my 22mm main stop tap & my 22mm home supply. This length of pipe is about 50 feet long. It goes from the front of the house to the rear. I want to replace this with 22mm. I have seen some...

I would love to, but I thought it would bring the height up too much, dont you have to lay the heating mat on insulation board, etc?

My shower room floor is re enforced concrete, sat, I believe on polystyrene slabs, which are sat on a blue type plastic sheet, (Built 7 years ago). The concrete was covered with asphalt then tiled. My problem is that the floor is higher than the adjoining room floor, & I want it level. If I...

Thanks.

My shower room floor is re enforced concrete, sat, I believe on polystyrene slabs, which are sat on a blue type plastic sheet, (Built 7 years ago). The concrete was covered with asphalt then tiled. My problem is that the floor is higher than the adjoining room floor, & I want it level. If I...

Many thanks. It certainly looks the part, thinner than most too, I like the reviews on it, one question, what power output or liters per second will I need for a good hot shower?

Ouch, thanks for that m8.

Ravenheat CSI 85AAA (T)-780 Series Cond Combi Can anyone give me any info on this boiler please, is it a good buy, are there any problems with it? Thanks

Hi, My lad has a halstead best 40 boiler which has failed to ignite, we had it serviced & it worked fine, then a week later, it failed again. it clicks as though trying to ignite, but theres no spark. before we get a fitter in can anyone advise me of the possible fault.

I had 3, MV222, 2 port motorised valves fitted about 18 months ago. Since then, all 3, & 2 of the replacements have failed, all with the same fault, duff actuators. I contacted Salus by e mail & sent them a bit of an angry mail, telling them their actuators were a load of crap. I was amazed...

Sorted. Thanks m8.

I`m in the process of fitting patio doors, or rather 2, 30 inch doors in a frame to form internal patio doors. I can either rebate the door edges so the doors will close to each other, or, leave the doors without a rebate so each door can be opened seperatly. Can anyone advise me what the...

Bummer. Thanks mate, better get me hammer out then.

Thanks for the reply m8, I really don't want to re board, is there no alternative?

I have done a search for this topic, I find posts regarding tiling over tiles etc, but not blocks. My downstairs shower room has block walls, with dot & dab standard plasterboard, covered with large 18 x 10 tiles, fixed with wickes floor & wall adhesive. The cement type stuff. I`m...

I have a Baxi brazillia 8s wall heater in my garage. Is it possible to convert the jet size so it will run on Propane? The gas injector is a CO1. I have made a few calls to registered corgi installers, one wants £75.00 just to come out & look, & one who tells me the heater is too old. I...

Thats exactly my concern m8, thanks.

Yes, absolutely. I didn't know you could get plastic cylinders. So, basically, there is no difference with the new s/s cyl to the copper one except for the increase in pressure, & the safety valves. Can anyone reccomend a good cyl, must fit through a 2 foot sq hatch. I want to be able to...