Search results

Well the alarm does have output for ultrasonic sensors but none with it and can't really find any?? What door switches could i get as that sounds a better idea, can you get ones like you have in a house that when contact is broken it activates alarm?

Looking to put an alarm in but have no manual or wiring diagram, any idea where I can or best way to find the signal wires for locking/door switches etc? I see on alarm outputs it has a Negative door trigger (-) and Positive door trigger (+). Mine seems to give plus 4v closed (not 12v)? so...

Just wondering, if i put one in my van would it work so if someone broke in at night my alarm ( if that pir was used in part arm) would sound and wake me up?

How do i access the smartcom to see what network it is accessing, think i may have it on a hub used as a repeater and want to change to my main hub ssid Is it basically a case of doing what i did to originally set it up? "Press and hold the WiFi button for 5 seconds until the WiFi LED starts...

blanks for the rear?

is that done in areas- options- part arm silent-(enter areas)? and/or keypads-keypad sounds

page 61 and 38 https://www.texe.com/uk/uploads/INS177-9_Premier_Elite_Series_Master_User_Guide.pdf

Thanks for this.

Is that option available with the TEXECOM CEL-0001 Texecom Connect SmartCom? is it done under arc setting Like image 2, i assume i remove the numbers that default into the tel number? Re the open close it says "Reports This option defines which events report to the Alarm Receiving Centre when...

Handy, will get one for my decoy box

Is there a setting anywhere where you can define what notifications get sent via the app?

i had similar, but it was because i logged into app as engineer not master.

Think I did similar, but all up and running now thanks

So at last it works, can connect my wintex via smartcom, can arm ( reason i could not ) was i had logged in as engineer and he can't arm the system!! log in as master problem solved.

No it was wintex, keeps losing the com port in setup

Picture of home screen no devices in fault mode and at home on phone and app Just realized it is z wave, handy for adding other smart devices then

Some photos

At this moment i am only using one area, that is named along with all my zones. I managed 1st time round to connect app, but i then disconnected the lead from com 1 so i could access the wintex. once removed and smart com connected again it just lost everything programmed for it, so i did the...

Ok cleared all the alarms, have set up all rooms and can now see door sensors live on app ( not motion though) but still only see disarmed in white and partly armed in white fully armed is greyed out. Had to go back in and set up again as when i disconnected to use wintex on com 1 everything to...

Managed to get smartcom set up and now connected via phone. I can however only use disarmed and part arm, full arm is greyed out. If i try part arm i get "System not ready. the app has detected that there is something preventing it from arming" Could it be i have alarms zone 17 (my back door...