Search results

I am looking at new kitchen downlights and came across these https://www.integral-led.com/products/downlights/evofire-70mm-cut-out-ip65-fire-rated-downlight-insulation-guard-and-gu10-holder Has anyone bought/used these before?

Both exceed 3.1KW and manufacturer states 16A supply. Combination microwave 3.6KW oven 3.5KW

If you have a microwave and an oven both rated at 16A and housed in same unit. What is the neatest way to power these. Would a 6mm cable on its own radial circuit be the way to go or two separate circuits

I use Knauf 12.5mm square edge and get it delivered from a builders merchant. If damaged i refuse them but had hardly none damaged as they take more care than Wickes.

I will be laying some 1200 x 230 tiles, should i be spreading the adhesive in direction of the length or would i get better coverage spreading in direction of width, i.e 230 direction?

Are these known for sticking. Being intermittent? Have one on Radiator zone of heating, and rads not always coming on as boiler cuts out early. Tested to see 240v when thermostat calls for heat and i have that, just seems valve not always opening. If I manually open it, it shuts down when stat...

Would it be best to use a 10mm trowel for this size floor tile?

nothing, just wondered if it could be used, thanks. Looking for a neutral cure one but not seeing any mention on descriptions if neutral or not.

Can Hawk white be used around seal on shower waste when installing new instead of silicon?

Having open plan lounge kitchen, wanted engineered wood throughout but a bit concerned having that in kitchen. My other option was a porcelain wood effect tile, then someone mentioned the karndean Korlock. has anyone fitted this before have any opinions on the karndean? Will suit the kitchen...

Do they suffer the same as ceramic where in high traffic areas the pattern wears.

Would anyone know if the Knopp's Contopp Accelerator is ok with UFH?

? To keep it at 6 bar while screeding, so if not leaking close valve and remove pump?

If i pressurise the system for screeding, once at pressure can i just close the filling valve and remove pressuriser, or do i need to keep that connected?

Does a female ½" BSP from Rothenberger RP30 pressuriser connect to a "normal ½" male connector such as http://www.screwfix.com/p/jg-speedfit-15mc-1-2-cylinder-connector-male/23662

So I guess making this forum pretty pointless. Yes I have some electrical knowledge but having not had to consider an island at this stage in the past, I see no harm in asking on a Forum questions relating to Trunking.

When it comes to having an electrician maybe not, at this point wiring is not actually needed just a means of getting it where it needs to go eventually . My plumber was not involved when we run ducting for the water mains, but he sure is glad we did

Ok Just to figure out the UFH pipes then to allow me to run the conduit

So would you run the 20mm Conduit under the celotex ( not recommended by Celotex) or run the conduit over the top of celotex within the screed.

Concrete floor being covered in 100mm celotex then wet ufh and screed. What would be best way to get power to island? Not to power any appliances only for a double socket to power laptops etc