Search results

Having undone the wires from the board that powers the motorised valves and the CH pump ( conventional system, not a combi), I seem to have put them back wrong as the boiler 13amp spur fuse blows when I switch it on I have not disturbed the right hand side of board so that must be okay. Photo...

Hi I have a lavamat 12830 wash dryer and as there is no longer any heating going on I suspect the heater element has gone. Calcified I expect. Is this easily accessible? I have done these on other machines before but the lavamat seems to only have access from the top, unless I fancy...

The sill on my sash is totally rotten and needs replacing. What I am unclear about is whether the sill and the bottom of the window, where the sash comes to rest, are all one piece of wood or whether the sill is separate and the join concealed. Could anyone advise? I feel I may be able to...

Hi One of the pros here but not local can supply me the parts I need for a Netaheat 10-16. Is there any pro in south london who would consider fitting them for me? Obviously I accept if parts are no good, I still pay the labour anyway. Pm me? S

hi I need a new boiler to replace my netaheat somewhere between meter and boiler, the 22 pipe has gone down to 15mm I am told that its not recommended to feed a new boiler from 15 but to change the pipe is going to be hell on the house structure and probably very ugly and expensive with...

Hi. May I say at the start I have no intention of carrying out any work myself but I would appreciate a heads up on what this problem may be so that I can evaluate the economic viability of my old boiler. It is a Netaheat 10-16 Mk2 F (yes I know they are regarded as widowmakers but its done...

Well I am stuck. The distance between the belt edge when around the drum and fully extended, toward where it needs to be on the motor spindle is 5 cm. It seems an unbridgeable gap. I know it should be tight and I have done it on other machines by putting it on the spindle first and then...

All that is stopping my fixing the belt on my Zanussi are the peculiar screws holding the lid on. They are standard hex screws except there is a raised point inside the screw that prevents my usual drivers going in. Is this some cunning trick by Zanussi to keep away amateurs or can the driver be...

demand > fan runs> pressure ok and gas valve opens with soft clunk> clicky clicky goes spark generator> pilot lights > main gas burners ignite Except the spark generator is not going 'clicky clicky' and so sequence holds at that point PCB or the generator at fault? Relay all fine and is...