Search results

thanks will look into them

Have just wired up the bellbox as per manual using connections ABCDS like for like at both panel and bell box. system is clear but bell box isn't operating. Have taken cover off and tamper doesn't even come up On the panel the right side led is flashing on the bell box also

it has an egress hinge already fitted but want the window to open beyond 90 degrees

Thanks it's a flying mullion window

Ah it's too late for that unfortunately

it's a garden bar

Already have these fitted. Trying to find a solution to get the windows to open right out

like this but outside

I have casement windows that I want to open fully outwards. They have standard on at the moment. I would like to open the windows fully out. is this possible?

Is this easy enough to do? Can these be purchased off the shelf?

I have just fitted some larch cladding and noticed some black spotting/mould appearing in places. Can anyone advise of a good product to remove it before I put a coat of oil on. thanks

Last piece to infil where the patio doors are and it's a piece that needs to be fitted tongue first. It's on 50mm wide but it keeps popping out. it will have a quadrant fitted over the gap between door and floor when finished. mess gonna hide the screw or nail under the quadrant any issues?

thanks Is there a smaller hinge as the Dior ones look quite big

Is that a possibility?

ok thanks that's a shame. Would Love them to open further back.

Can I get more open than this...

Hi is there a hinge that can replace the standard restrictor/hinge on a pvc window so the window can be opened back further

Looking for some small downlights to instal into soffits of a garden room. ideally no more than 50mm in diameter or cut out and finished in black. Prefer dimmable if possible. Any recommendations. thanks

I have a garden room which I’m in the process of building. I have decided to go down the cold roof design. I can achieve 50mm ventilation front to back of the building as the joists run in that direction however I have a side overhang which has been built by cantilever off the front to back...

I have an electrician booked in to connect a 6mm SWA cable from a dedicated 32amp RCD breaker in the house fuse board. The other end of the SWA is going to be connected into a rotary isolator for the hot tub. Can a new weatherproof double socket be spurred from the rotary isolator?