Search results

I've checked this morning. They are copper pipes and the sizes you suggest.

Thanks for that.

I will check in the morning.

When the hot water was on I could here a lot of water going down the condensate pipe but I assume that is nothing to do with the water discharging through the copper pipes outside, just a coincidence.

Thanks. Do I take it that overheating is involved and heating is not been switched off?

I have attached an image of external pipework at the front of my house. I noticed a couple of days ago that water was dripping from one of the pipes whilst the boiler was heating hot water. Should I be concerned? Thanks.

Thanks. That was the information I was looking for.

Thanks. I take it I should be supplying some more information.

I have a Worcester Bosch 24Kw gas boiler. The knob/dial indicating boiler temperature max/min just has a black line on it, not figures in degrees C. There is an optimum temp recommended for efficient boiler output so just a line is of little use. Is there a way around this issue, other than...

Thanks. I can see what the issue is now.

Except that the cistern does not tighten up. There are no holes in the cistern, it sits on the washer and is fixed to the back wall. The new washer raises the cistern higher than the fixing holes in the wall even when the weight of the cistern is applied. The older washer does look a lot...

Thanks. The instruction for the coupling says......."so that the flat face is in contact with the plate." Have I misread it?

I have attached a photo of a cistern coupling washer which I'm replacing with a new one shown in position 60mm I/D. Will the new washer work? It is supposed to, but there is an obvious difference in the O/D size. I positioned the cistern on the new plate and rubber washer but the cistern sits...

Thanks. The outside dia of the threaded pipe is given as 1.5 inches on the syphon I was looking at.

Thanks. Will the fluidmaster fit an external lever flush?

Whilst sourcing a toilet cistern syphon I've noticed that every outflow pipe dia is 38mm whilst the hole on my cistern to take a new syphon is 50mm dia. There cold be a problem when tightening up the nut onto the rubber washer ie not enough material to tighten up onto. Have I got an unusual...

Thanks.

Thanks everyone. I should have said that the metal part of the plug is 12 mm long.

Does anybody know where I can purchase a DC 9V-12V radio plug similar to the attached but not a sealed unit? The plug is 5.5mm outside dia and appears to be 2.0mm inside dia. The plug is positive centered. The amount of similar plugs available is rather like a minefield! Thanks.

Thanks.