Search results

Definitely does nothing. Turned it round to 0 last night & still radiator was warm / hot. So from memory the other end has a white conical shaped plastic cap. You saying below it is like a 8mm shaft ? We can then leave it like this until winter when we can then unscrew this end as opposed...

Old lady across the road said her bedroom is baking & could I turn the radiator off. In the attached photo turning the white part all the way around to 0 does nothing in respect of cooling it at all. Can that valve be taken off so then it does what she wants it to ? If so please advise how...

That’s it. Once the top was off he pulled out a small round part with as a little chimney. Also a rubber gasket with 3 what looked like spark plugs so I assume some kind of ignition system. What’s the cost of the part ? Also pump cost ? Only rough as curious.

Looked like a silver fire extinguisher. Popped the lid off & there were lots of fins of which I expect the water passes through.

B Gas came out yesterday & did a few tests. Told it was the pump & had one on the van so it was changed. Sink in kitchen was used to run hot water but after say 2 minutes tripped which was the original fault. He can back this morning & had a big silver cylindrical part, must of been say 16...

Ok thanks

Only time they’ve been here is for this issue. Don’t do any fault finding just tell you what it is & change a part probably just want to get to next job. Only then to come out again 2 weeks later. I notice if I have hit tap on fast in shower or Bath it does happen but should have to turn it...

Not having anything to compare it with I would say slow. I didn’t watch him change it but when looking up from underneath I would say it’s about 10 inches long and probably flat at the back by the wall. Make sense ?

Hi, Not sure if boiler model as can’t see any labels but look like attached photos. About 3 months ago is when the issue started. I could be in the shower & after a few minutes the water in cold. Having to get out covered in soap & press the reset button. I then started to use the bath but...

More like 1

I now attached photo showing which item is flashing.

Neighbour has the boiler mentioned & has no hot water or central heating. The is a red light flashing next to the red reset button. The boiler pressure seems low to me but photo attached to show you. I have pressed the red reset button for 5 seconds then I could hear say the boiler hum but...

I had seen it mentioned 2 wire but didn’t see what the 2 wires were. You mentioned live & switched live. So does that mean the above is the same or not ?

So going by the member saying it’s 2 wire can I use the following stat & wiring also shown, please advise thanks .

I since found that it’s 2 wire. It also mentioned no earth or neutral so live & switched live mentioned above would sound correct. So do I now just look for a 2 wire stat ?

Looking to replace this old intermittent stat control. Danfoss TP5E I’m not local to it at present as it’s at my sisters, I’ve been looking for a installation guide to see how many wires there are but only found user manual. Anybody know how many wires ? My goal is to remove this from the...

Yep all that was done. Supposed to be here today but they said nothing was booked which is rubbish as B Gas even put a notice on my Google calendar but they denied it all, they are here tomorrow so another 1/2 day wasted waiting for them.

Controller i just move from room to room so not wall mounted Received is on wall next to boiler in kitchen You say thermostat so is that the controller ?

Yes I do, Original post was a week ago etc & tonight’s post was couldn’t understand why all new Duracell are showing as flat on controller and all show 1.8v with meter

I believe it’s a green star ? Ref hot water I just turn tap on and it runs hot. The batteries at present are all new & read 1.8v each but when fitting in the controller the controller shows the low battery light as in photo above. The issue was the controller would turn itself on to a random...