Search results

Hi, I've got a Beko DPU8360W Condensing dryer that is making a strange noise. Anyone any idea what it might be from listening to the attached clip? The noise is happening at the start and then again at 11 seconds in. It's an intermittent issue - it started a few months ago - when it happens...

I'm re-grouting the floor on the wet room as the grout had cracked and water was getting through especially around the drain area. Would someone be able to advise on a suitable adhesive or cement to use to re-fix a few 1" marble mosaic tiles in a wet room. I was thinking that maybe OB1...

I have a mosaic marble shower which after 7 years has started leaking. There are some small cracks in the grout around the drain Shower1 by austin99 posted 14 Mar 2021 at 6:16 PM I put some silicon sealant in this area as a temporary measure and also to see where the leak was coming from -...

I have a Greenstar 36CDi combi boiler with a Hive (single channel) thermostat. There are two circuits, downstairs & upstairs - the Hive controls downstairs and it works correctly. We don't use the heating that much upstairs, maybe boost it for 30 mins every now and then. I presume I could...

Question; is electric underfloor, i.e. a Devimat, completely OTT to put into a tiled floor bathroom when it will already have a convection radiator in there anyway? The radiator will certainly heat the bathroom properly but will it take the chill from the tiles on the floor sufficiently during...

Hi there, Looking for some advice about installing a replacement alarm system. I've installed several DSC PC1832 panels in the past - with wired and wireless sensors. The panel does work but it is a pain to configure, also I've found the wireless sensors to sometimes be a little bit...

Hi there, Currently getting a house refurbished (and properly insulated) with a new CH system. Have very basic hot water requirements (there's a Triton electric shower there already) so was going use a combi boiler and get rid of the old hot water cylinder to get a little bit more storage...

Hi there, I currently have a dual dimmer switch which is wired as two separate single pole switches. For each light circuit I have just two wires into two separate dimmer modules. I want to replace this with another dual dimmer switch which supports home automation (z-wave) and unfortunately...