Search results

Trying to put a new bathroom right in middle of semi-detached house, on the second floor. It will have to be a 90degree pan connector and then a 4.5m horizontal run just to get to the external wall (can get a 10cm fall over the 4.5m), then the main soil stack is about another 2.2m and...

Lining the chimney while I have good scaffolding up on roof. I had to rebuild top of chimney and pots were off anyway. So I have gone for a top clamp on a flexible 5" /125mm stainless steel liner. Flue went in chimney pretty easy. And this top clamp seems to hold it ok. The bolts are tightened...

I've laid about 30sqm of normal 16mm underfloor heating pipe under a new concrete floor. One reel of 100m and another of about 70m. I have a new 30kW combi boiler. I read you should have a direct connection to the boiler for the UFH manifold. I have 22mm flow and return pipes quite close to...

I've got access to my chimney stack with some other roof work going on. It's a pretty standard, straight-up double chimney stack in an old house - one flue goes to ground floor and is still in use (lined with woodburner), the other flue goes to a disused fireplace in a first floor bedroom...

I'm putting in a new inspection chamber where the main soil stack from three toilets goes into a combined sewer down a narrow side passage. Due to other pipework, am fitting one of the small 300mm diameter chambers like this...

Just taken wallpaper off a house built about 1905. There is damp, probably rising in some of the house but not this room. Is the grey plaster up to about a metre off the floor special waterproof plaster from damp-proofing? I can't see any injection holes but guess they might be under this...

We're working with an architect and structural engineer to design a loft conversion. Suburban semi and pretty standard - keep front roof and dormer to rear. We are going for full planning application rather than permitted development. Surprise was that architect says new loft walls need to be...

Got a long run of lead pipe going from water meter on pavement outside house to kitchen at the rear. Have dug most of a trench for a new plastic pipe: But there is a big drain pipe blocking access to the water meter at normal water pipe depth of 750mm (marked 2 on this pic, also showing Water...

I've made a new first-floor bathroom with a toilet on a wall over the side passage. The main combined rainwater/sewage drain runs under the middle of the side passage. So I thought it would be easy to make a new soil stack into the existing drain. But now I think it's quite hard, access is...

I'm about to tile an alcove shower. I'm using 13mm marble tiles on to tanked Aquapanel. I want to put some small shelves in for shower gel and stuff. The chrome ones look tatty quickly I've found. And I haven't got the right studwork now for an alcove. So how about just using the tiles...

Sanding up old pine floorboards, maybe up to 100 years old. Rough sand of most of them went ok, but round the edges there is a thick, sticky black paint that I'm really struggling to shift (see pics below). It seems to go pretty deep into the wood. If I can shift the paint, thinking of dyeing...

I'm redoing the main bedroom in an old solid-brick semi and the bed is going along an external wall with chimney breast. The alcoves aren't really deep enough to do much with. As it's being skimmed anyway, should I fit some thin internal insulation into the alcoves? I'm thinking one of these...

Hi, I'm fitting a new first-floor shower and the edges will not be above joists. Which option is best? 1 replace all the floorboards then just screw 18mm structural ply into the boards, and into joists where can. 2 remove all boards, reinforce joists with new noggins to provide support along...

I had my food dye ready to try to figure out what was going on with drains in my new house, lifted the manhole cover and found this... There are pipes at each end that look a bit like clay underground drains, and are at right-angles to the road (where main drain probably goes). I flushed a...

Have just bought quite a bit of Red Grandis, a cheap hardwood in the Eucalyptus family, to make some cupboard doors. In its natural state it's much pinker than I realised - and than I want. It's got a good grain though, so I'm guessing it should look good if I stain it with something. I...

Hi, Anyone tried Grundfos macerators? They seem to be cheaper than Saniflo, and I've had two Saniflos (lucky me, huh) and one of them has been nothing but trouble, although must admit the other one has been ok. Apart from price I like the Grundfos because I think they can cope with 22mm...

Hello, I'm about to bury some plumbing behind some tiles so I'd really like to get it right. I bought a Mira shower and you are supposed to fit it to a partition like this: I have bought these from Wall Plate Elbows Toolstation to get me from Polyplumb 15mm too the shower fixing of a...

Hi, I've bought this bath: http://www.bathstore.com/products/showertime-thermaform-bath-1899.html and am installing it in a bathroom where it will be surrounded by walls on three sides. The bath instructions say to batten under the rim to give additional support which sounds like a...

Hi, I've used Aquapanel before for tiling bathrooms with heavy (12mm marble) tiles. Doing another one now but have seen this British Gypsum Glasroc Tilebacker H: http://www.builderdepot.co.uk/british-gypsum-12-5mm-x-900mm-x-1200mm-glasroc-h-tilebacker.html It's quite a lot cheaper than...

Hi I've got two dimmable 4W LED bulbs in downlighters (in series). I bought this dimmer: http://www.tlc-direct.co.uk/Products/VLJQP252W.html because TLC advertised it as having a minimum load of 3W. I fitted it and the dimming is almost non-existent, maybe 5% or so. Now going back to the...