Search results

I discovered a leaking pipe inside a kitchen cabinet. Unfortunately a bit of damage already done. The edge banding of the MDF has curled away leaving an unsightly gap. Will a warm iron after applying some glue into the gap fix this? How would you fix this.

Our flowmaster cistern filler identical to this one has a failing closing valve. It's not stopping the mains water flow when the float rises up to the top. Can the valve seal be replaced?

I nicked a plastic central heating pipe with the grinder. I'm surprised its not leaking. Quite deep, actually amazed its not leaking. Is there something, a glue or epoxy I can coat round it that will make it good as new, something like a putty?

The roof is concerete tiles. I have a lot of moss on the north side of the roof where the roof gets less sun. It eventually rolls off and fills the gutters Is there anything I can spray, or put on the roof to reduce or stop the moss build up?

I am re-doing facias and soffits, which means new gutters. Currently fitted are half round gutters but deep egg gutters have been suggested for the new install. No one seems to need the run off capacity of deep egg gutters(?), so why do they exist. Installers seem to recommend "deep flow"...

Have a Garage Flat roof 8m x 7m. Very slight run off on it. I needs replacing. What's the best solution for replacing it?

I have a down pipe from the gutter, that goes down the side of the house and goes into a ground drain. Diagram below. I can get my arm all the way down to the blockage and have completely cleared that far, but can't reach round the 90 degree bend, shown, to get to the rest of the blockage. I...

I have a 2013 VW golf 1.6 TDi. It is not Euro6 emissions compliant. I wish to bring it up to Euro 6. I have had a look around and it seems there are no conversion kits. This is an emissions issue for filtering the exaust particulate as I understand things. How do you build an exaust filter to...

Boiler stopped working and found condensate drain from a combi boiler capped as shown in the picture. Can I simply join this in to the sink waste after the u-bend / trap in the indicated location?

This old window just about closes but will not close the last 1cm or so, meaning rain comes in during a rain storm. It hasn't "clunked" closed, as they do when they are working properly, for a long time, but this is the first time that water has come in. The old closing mechanism was replaced...

Seal is fine when ring nut is tight but it keeps coming loose. Is there a "loctite" or other means of creating more friction between the ring nut and the steel it tightens on to, so it won't come loose again. How would you do this?

Have a sink and periodically the kitchen sink drain assembly unscrews, underneath the sink, causing a leak. It's all help together underneath by a 2 inch nut, or a nut approximately that size. What kind of glue can I use to cause enough friction so that it will come off when need be, but will...

4" half round PVC gutter came down during recent storm. End corner broke off as it hit ground with single clean break. Gutter is old but solid, not brittle. Will poly cement put it back together with decent structural bond ?

Hi, We are replacing our bathroom and have found waste pipe of various diameters, including stuff marked in inches. All the different sizes are confusing and the OD's don't seem to match the name. Is there a Waste pipe chart somewhere with, OD diameter by known name

We have to excavate a hole in a stone wall which is approx 60cm thick so we can put a soil pipe through it. Having removed plasterboard we see a pre-existing hole in the wall which is 1.4 m wide by 23 cm to 67 cm in height. It's a deep hole that goes through most of the wall but not all the way...

Shown connection to clay waste coming in at steep angle from toilet directly behind wall. We are moving toilet further away from the wall and so need shallower angle of connection all the way to clay pipe to get steady drop over the distance. We are not using a mascerator because of sanitary...

Danfoss SET1E heating timer, it is showing red LED light but LCD is blank for all positions of grey switch on the right, it shows nothing. Does not appear to have reset button underneath. Ideas how to get LCD showing again/ or a fix.

I have a window with a crack that ran years ago when the wooden frame expanded a little and I had to force the window to close it. It's never run any more and there is no shelling. Is there any fluid/ glue I can put into this to asthetically remove the visual effect of the crack and bond it.

Laminate floor board springs up and down. I did not fit it and have no idea who did. Cannot realistically lift floor from edges to support underneath as out of time. I think either the board was butted wrong way round without tounge into groove, ie slotted in wrong way, or groove has collapsed...

We have a stable with no windows and it is a black black space, becasue ever with the single light on it is still dark. We are going to be doing lots of works in there so need to get it well lit. Dimensions are 5.4m x 3.55m. We can string lighting across the whole of the 5.4m dimension...