Search results

I have lifted old linoleum that was glued down. In lifting the old linoleum some of the plywood has been damaged, some thin veneers have lifted leaving soon obvious indentations that require making good. Is there a product that I can use to make good the plywood surface so that it will be...

thanks!

Hi I have an existing slate floor that looks good wet but not so when dry. Is there a product out there that will give a permanent "wet look" finish. The floor has already been sealed and is dirty so I would probably need to strip that off. What product would I use for preping the...

Many thanks shorky for taking the time to reply, your advice was very helpfull. Regards

I have a new Franke sink to install. It came with 2 washers for the waste, one is rubber with ridges one side and flat the other. The other washer is a felt-like material. I am guessing that the felt one goes under the waste on top of the sink and the rubber one goes under the sink with...

I have installed a Baumatic cooker hood in accordance with maufacturers instructions but when I switch on there is a crackling sound coming from the 3amp fused connector unit. I also had a mains powered radio on in the next room at the time and the sound went right down when I switched the...

I need advice please. For some reason my kitchen floor is made up of half concrete screed and the other half is timber floor boards. The boards finish level with the top of the screed and there is vinyl over the top of the lot. I am laying slate tiles so do I put down plywood over the whole...

*** FOUND ANOTHER POST DISCUSSING THIS PLEASE IGNORE ***

Many thanks for the advice.

Many thanks for your help

I cant seem to be able to get a 3A FCU locally can I use a 13A FCU and put in a 3A fuse? Sorry if this seems a dumb question. Thanks in advance

I have got three fluorescent tube type under-cabinet lighting units that I want to wire to the main kitchen light switch so as I turn on the main light the cabinet lights come on as well. They daisy chain together and the last one has a wire coming out with exposed ends where it was previously...

all done now! thanks for your help

Is that 2 pieces or one piece, sorry I am not to clear. Thanks again

LOL :D

The gradient is not good at the moment but I will make it steeper when I replace it. 20mm in 1m I heard was the correct fall. Thanks for replying

Dear all I have to replace the washbasin waste in my bathroom. The total length of run is just over 3.5m. The existing 32mm waste runs from the bottle trap to the outside then drops down and joins vertically into the horizontal 40mm bath waste outside the building via a swept tee. Water...