Search results

Hi Guys can any one make some suggestions how to remove the walls under said roof

thanks for that , its no-good getting a sander on it blocks up in 30 sec i'll try the wire wool idea

Hi Guys I have a beech work top that her indoors wants re-furbishing which is a simple enough job with a belt sander and a detail sander????. Question is how do I remove the built up oil so it doesn't block the sander I got a belt cleaning block but spent more time un clogging the belt...

and all I wanted was a guide price to have the kitchen plastered. LOL £1500 in 4 days !!!! , the trains from all points south are now full of eastern Europeans . with a Plasters trowel . charging £150 a room

no plasters left in the midlands all way up north earning £400 a day .

down they should be sold to the french they can't play footballs but the foods good

Hi can any one please give me guide price re plaster a room 1960 X 5520 ceiling needs over boarding walls skimming over ?? house is 1920 's if interested in quoting it;s in wolverhampton

Thanks so no re bar or suchlike , I should know all this 25 yeas ago i was contracts manager for RPC mind never pored a spade full of the stuff but good with bar marks LOL , Is it ok just to poor up the existing slab

Sorry to be a pain , as it's damp enough out there would it be better if i lifted the slabs and put a DPC under the concrete I do know there is hard core under them ?

Hi I have a 5 foot covered passageway between my house and so called out buildings , so brick work one side existing concrete slab the other which is at the highest point is a 5 inch step-down to 1 inch so I want to take the slope from the front back to to the back back door and level it up...

HI The Sand and water was a figure of speech , the bricks are old and have little substance , the old plaster is not being used to fix to but the brick However because of there porous nature I don't want to rely totally on the raw plugs , As use and weight will in time work them loose ...

Hi I have to fit a hand rail onto the wall of venerable relatives stair there is an existing banister but age demands that two rails are requird . the job it's self is not a problem what the problem the house is so old and the bricks are made with sand and water and crumble if drilled ,i could...

Hi I now have time to start a long running project which is removing one of the wallsfrom under a 4inch cast in situ concrete roof . thoughts on using a LINTEL STEEL BOX K150 instead of an RSJ it would be a lot lighter.

have sold boat to fund gas bill :D ,do i open the fireplace up and use the exsisting gas point or just get an electric heater . I did fancy a wall hung in the whole heater as I have a FLUE . so no CO alarm required

Whats the cheapest to run I have a boarded up fire place and am trying to cut the cost of heating by heating the lounge when we are in it instead of having the heating on the heat the whole house during the warmer months

Hi I have had my old shower removed and pulled the cable back to the fuse board . Can i pull it through the wall and add a garage distribution board which will supply two sockets , and a light . I am capable of doing it . question can i do it ?????????????????????

I think I can manage that , If I get confused i'll be on here bothering you again . !!!

Hi Wabbitpoo It not good under there, went out today and had a look , there are only 5 suport posts and that includes two cornes , the joists are approx 2 meters apart .the end joist is'nt attached to the ledger board so the newl is twisting the joist so the hand rail is lose ,I could go on...

Hi Thermo over the 3mtr the bow is approx 24mm in the middle

Hi I have a decking thats approx 24 inch from the ground , It's to small and is bowed in the middle because the muppet who built it put the legs straght onto an old lawn and they have sunk , to save myself some cash my plan is ??? To remove the decking boards and extend the subframe then re...