Search results

Ok Guys The heating was playing up the other day, so had the pump changed by a plumber. Then we noticed that the heating would only cut in once the hot water was called for(i.e. tonight no central heating, ran hot water for a while and boiler and pump cuts in and heating comes on!!!!). I have...

I was wondering if it should be at base of cylinder but it's been ok for most of the time

I have a salamander CT 75 Shower pump. Cold tank in the loft hot tank in airing cupboard pump sits on top of hot tank. The pump works intermittently from start, switch it off an on a couple of times it will work. After a couple of mins the shower stops, lower the shower head (type on a...

Thank you

Thank you for your reply, but what I want to know is do I start laying a the long wall and finish at the small door area or start at the small door area and finish at the long wall.

I have a bedroom that is 2.4m x 4.6m and the door entrance is is an area to the side of the long length of 1.2m x 0.6m (so L shaped) I want to lay a laminate floor where should I start the long length or the small door area?? I have layed floors before in 5 other rooms but they were all...

I have the same problem any advice where to buy baskets with cut away corners

so what are the best pumps

I have 2 showers one with a large head and one a normal head the flow to the large head is very poor. i have a gravity feed vented cylinder. it has been sugested i either use a twin pump or change to an unvented cylinder. i have been quoted £500 pounds to supply and fit a salamander pump...

smeg dish washer E1 & E2 code tried reset, switch on 4 presses of program button, switch of for 20 seconds still has E1 or E2 Code, machine fills heats up then stops with same problem reset again and then pump just keeps cutting in and out at about 1 second intervals empties water from machine...

3port divertor valve not wired up correctly took electrician 15mins to sort

Boiler fails to start after short time of no demand. have to mess about switching boiler on and off changing over pump speeds and then then boiler starts. but comes up with -ll- and boiler flow temp. Book says trap filling is in progess but should only happen after long periods of in activity.

Fitted NRV to shower hot water pipe now all fine.

Could i fit a NRV into the the cold fill line to the boiler

Ok changed midpoint valve to diverter valve problem still exists with cold water tank heating up. NRVs in pipes to shower mixer tap, sink mixer has isolation valves. If i turn off the boiler and pump and use immersion heater to warm water and hot water does not back up to the cold water tank...

I am at work now i will have a look when i get home as the heating will be off and your theory tells me that the cold water header tank should still be leaking through the overflow. After 1 1/2 hours of the system in service again this morning (ie the system being shut off all night) the...

The hot water was on and you could see the back feed in the cold water tank. turned the hot water tank thermostat down and upped the central heating thermostat and the water is still back feeding. Run some hot water off and then it takes a while for the cold tank to back fill again from the hot...

A plumber fitted the shower and while the floor boards were up he ran two pipes from the hot water tank cupboard to shower pipe area behind the bath panel. so i suppose you could use one of these pipes to the cold water header tank.

To gravity feed the cold water is a big job as i have just tiled bathroom floor and walls. is there an alternative

So leaving the check vales out is the problem???? There is no pump to boost the pressure all though he has run the pipes under the floor just incase they are required So i need to fit check valves to hot and cold shower feed or a pressure reducing valve to the cold feed and that should...