Search results

Ye it does. Thanks all.

Brilliant. Thanks for replying. So just use that with a standard brass nut over it then? How does it seal?

I'm half way through installing an outside tap for the Mrs. In my wisdom(lack of) I decided to replicate what I installed at my own house a few years ago. Pics attached. I didn't buy a kit for her however I'm wondering if I did when I installed mine. Can't recall. Anyway. I have a flexi hose...

Thanks both. Is that all I need Andy? I'll order that now for collection tomorrow if so.

Hello, I'm in the process of installing a dishwasher but was unsure if I'd need to swap out the entire kitchen trap for one with two waste hose connections, or if there is a Y splitter or something available allowing me to adapt the one that currently exists which receives the wash machine...

So basically, go with a 900 door. Ditch the wall profiles that come with it, then use aftermarket wall profiles that have a little more reach? Is that basically how it works?

Hi folks, I've got a bit of an issue whereby I've installed a 760x1000mm shower tray but unable to locate a suitable door for it! Pic attached. Ideally I'm after a hinged or pivot frameless door. I seem to be smack bang in no man's land between a 900 and a 1000 door. My smallest entry...

Hi All, I'm in the process of doing up my en suite however I'm having some some teething issues with my new WC. I'm using a macalpine Mac-8 from the soil pipe, and whilst it appears to couple onto the WC OK when I push the WC back against the wall, it clearly isn't as after a while I notice a...

Sorted!

Very true. I'll try my luck first . Thanks mate

Actually, you know what, I've got a decent 3d printer. I'll go with your idea of that shallow bottle trap. I'll very quickly knock up a new lower U shape profile on Autocad then fit that! Job done. Cheers

Ye, it's too big. I've just measured front the top side of the u profile up to the sink thread. There is only 12 cm. Not sure that link I sent is even going to fit either

Ye just height that's the issue. So, good left to right. Great stuff. I'll try collect one tomorrow. Appreciate you taking the time to advise.

Thanks for responding. Something like below? the https://mcalpineplumbing.com/traps/bottle-traps/e10-114-shallow-bottle-trap-use-basins

Hi folks, Is there any way I could offset the basin trap without touching the basin, to stop said trap from fowling the top drawer? Its only by a baw hair too! The sink is so bloody impracticable/unsymmetrical, and I've struggled with placements etc. The u shape profile on top drawer only just...

Thanks again. So am I looking for something like a FLOPLAST BOSS ADAPTOR 32MM 5 PACK (41571)

Hi folks, The 32mm push fit pipe system on the right is fairly new piping which terminates in the same size of rubber grommet type interface as the one on the left which is solvent weld (original pipes) , not sure what size but think slightly bigger! They both used to be tye solvent weld...

Hi folks, I was wondering if there is a COTS finishing cap available to block off that last piece of cladding which meets the gutter? Every year I get starlings and house sparrows nesting in all 4 corners of my house. The last cap is open, so. It's currently very simple for them to gain access...

Morning All, I need to patch a dodgy hatch that the builders left me in my 11 year old house. I automatically assumed it'd be 22mm flooring I'd need, but when I measured my current floor with my calipers it's measuring 24mm. Was there an older standard 11 years ago, or will the new piece...

I done this last year using a cheap multitool. I used an old piece of laminate floor as my offset and saw guide, then ran the tool right along it. Took minutes. I wanted to conceal speaker cable before my new carpet was laid.