Search results

  1. K

    Repressurizing the boiler with external filling loop

    I have a Glow Warm Felxicom which is displaying 0.4 for system pressure. Hot water/ heating are still working but on the label it says to repressurize if it goes below 0.5. There is no filling loop below the boiler, but there is what looks like one in the next room by the water tanks. I seem to...
  2. K

    Fixing a shower screen over a bath with uneven surface

    I would like to fit a fixed shower screen over the bathtub but both the wall and the end of the bath have tiles which sticks out quite a bit, I would say 7-10mm. What would be the best way to achive this? I have considered removing the tile side border which would allow the screen to be put...
  3. K

    Dishwasher leaking, need advice

    I have a slimline Beko DE 2542 FW dishwasher. It leaks. Lots of water on the floor, the water comes from the front side, I can see it trickling down between the door and the hinge. I have checked the seal around the door and it looks in very good condition. It started with a small leak and...
  4. K

    live wire detector-needed?

    I have to put up a number of shelves and cabinets in my flat. It is a council property so I assume the wiring is done to regulation, so cables should run up or down from plugs etc. However, I still not feel very confident as there seem to be many plugs, pipes etc. I bought a stud/ wire locator...
  5. K

    electric oven and hob plug- hard wire

    Hi. I need some advice with the installation of my electric oven and hob. The oven is a New World NW60F and needs 1925 w, and the hob is an Ariston system 2000 which draws 7000w. I am thinking of use a plug and socket for the oven and I assume the hob needs to be hard wired. The image shows what...
  6. K

    Dishwasher/ washing machine y outlet

    The cold water feed for the washing machine needs to accommodate the dishwasher. I bought a Y plastic adaptors and it leaked very badly, bought a better quality one (made of slightly harder plastic) but it also leaks, although not so much. I have tried tighten them lightly at first and...
  7. K

    washing machine waste hose cut off

    I have inadvertently damaged the washing machine waste hose and had to cut off the rubber connector at the end. The hose must connect to an outlet (not straight into the waste pipe) and I cannot find a connector that would either fit the end of the hose (so I can connect it to the outlet) or...
  8. K

    replacing old stinky wet room with bath tub

    I have recently moved into a rented property which has a wet room and an electric shower. It is a small wet room (200cm x 180cm). Hot water is supplied by Megaflo 125 hot water system for bathroom basin and kitchen sink only. I would like to replace the wet room with a bath tube, keeping the...
Back
Top