Search results

Update, I have now sorted this problem by uninstalling the thermostat and heat link and then reinstalling them, jobs a good un. Thanks for looking anyway.

Hi, I have a wireless Nest E thermostat and it has worked fine for 4 years but a couple of days ago it went offline and it now has a picture on the display as shown in the photo, no matter if I switch off and on it is completely unresponsive. Has anyone come across a similar thing and do you...

I have checked the outputs and they are set as you say they should be.

I did program the alarm and didn't play around with the outputs as far as I can remember, and the only jumper pin I can see is for the comfort led's, it's the five white ones i was wondering about.

I haven't tried it in test mode but if I set the alarm off the the outside alarm sounds and the inside one as well. Everything works perfectly except the white Led's

Thank you for your help, have you any idea how to enable them because they don't light up when the alarm sounds.

I have a pyronix wireless alarm and when I changed the battery in the delta bell box I noticed the two red led's which flash and five white led's which don't light up. Are they supposed to flash when the alarm goes off? and if yes, how do I enable them? Thank you

Thanks for your reply, it's the stripping and getting rid of the cement sheets I didn't want to deal with, I was hoping I could lay new sheets over the top.

My garage roof is corrugated cement/asbestos panels which are in a poor condition. In winter they are very porous and get saturated, and water drips through into my garage. I can't really afford to get the whole lot replaced and was wondering what those with the knowledge think about over...

Hi I have seen a mcalpine shower waste trap online which is much more expensive than most others and was wondering whether skilled men or others who contribute to this forum think they are worth the extra expence. Thank you

Thanks for that, just what I wanted to hear.

Hi, I want to fit a strap boss for my shower to drain to the main waste pipe but the only place I can get access is about 12 inches below and at 90 degrees to the toilet waste, would this be ok? Thanks for your help

Thanks for your reply Ian, that's what I thought but it's good to get advice from an expert.

Hi I have a Worcester Bosch 30I combi boiler, the domestic hot water pipes get to my taps by travelling half way around the house so I want to alter them to make the route shorter and get hot water faster and more economically. My question is to do this do I have to drain my whole heating and...

Thanks for that, I will take a look, any other ideas?

I have a similar problem with my alarm, did you find a solution?

Sparky I could get my meter probes onto the switch terminals and saw the reading go to zero ohms when the switch was pressed. If entering the engineers code should reset the alarm then I agree, the board must be faulty. thanks for your help.

My alarm has all the default settings still in so yes I have the engineers code, It gives me all the options described in the programming manual, but I cant find any reference to resetting a tamper alarm.

The thing is I don't know how to do an engineers reset. I have the engineers code number, should just entering this reset the tamper alarm? or is there some other way of resetting it when I am in engineers mode, I cant think of any info i'm holding back, why would I?

I have checked the tamper switch with my meter and it is working ok, I tried Pyronix help and support but they only deal with trade customers so no joy there. The alarm still works fine but the tamper message is really bugging me. would a clean start sort it out?