Search results

Hi, I have a wireless Nest E thermostat and it has worked fine for 4 years but a couple of days ago it went offline and it now has a picture on the display as shown in the photo, no matter if I switch off and on it is completely unresponsive. Has anyone come across a similar thing and do you...

I have a pyronix wireless alarm and when I changed the battery in the delta bell box I noticed the two red led's which flash and five white led's which don't light up. Are they supposed to flash when the alarm goes off? and if yes, how do I enable them? Thank you

My garage roof is corrugated cement/asbestos panels which are in a poor condition. In winter they are very porous and get saturated, and water drips through into my garage. I can't really afford to get the whole lot replaced and was wondering what those with the knowledge think about over...

Hi I have seen a mcalpine shower waste trap online which is much more expensive than most others and was wondering whether skilled men or others who contribute to this forum think they are worth the extra expence. Thank you

Hi, I want to fit a strap boss for my shower to drain to the main waste pipe but the only place I can get access is about 12 inches below and at 90 degrees to the toilet waste, would this be ok? Thanks for your help

Hi I have a Worcester Bosch 30I combi boiler, the domestic hot water pipes get to my taps by travelling half way around the house so I want to alter them to make the route shorter and get hot water faster and more economically. My question is to do this do I have to drain my whole heating and...

Hi I would appreciate any help to reset a control panel tamper alarm on my pyronix enforcer control panel. I put the alarm in engineer mode and opened the control panel and when I closed it up I have the tamper alarm and I can't reset it. I have searched through the programming manual with no...

Hi, the towel rail in my bathroom needs bleeding every few days, I assume that is because it is the highest on the system. I have tested the gas that bleeds off as suggested in other places on the forum and it is Hydrogen, or at least its flammable. I have read on the forum that this is caused...

Hi I am in the proccess of fitting a new kitchen and was wondering about the best place to put the radiator. the kitchen is 4.5m x 3.5m and on one wall I have a space between the wall and a tall cooker housing which is about 1m wide, I would like to fit a vertically mounted rad in this corner...

Hi, I have a towel warmer/radiator in my bathroom and the problem is it needs bleeding around once a month. Because of its shape it is the highest rad on the system. When I bleed the air out it's fine but within a month the top third is cold again. Can anybody tell me why this may be happening...

Hi I am fitting a new kitchen and will be having a 3.7kw built in single oven and a 3.2kw grill/microwave combi built in oven, I will also have a hob which I intend to connect to my existing cooker supply. Can you please tell me what type of supply I need to have fitted for for these...

Hi I have had ceramic floor tiles on my conservatory floor for 12 years, the floor was asphalt originally. I would now like to lift these tiles and replace them with a wood floor. My question is are they likely to come up easily and am I likely to damage the asphalt in doing so. thanks

I have been looking for some internal french doors and have seen advertised pattern 10 and pattern 20 doors, to me they look just the same. Can anyone tell me what the difference between the two is please.