Search results

  1. E

    Best way to cut up a metal bed base

    Thanks for the responses, I think I'm either going to go with @JobAndKnock suggestion or putting a metal bar inside of the two halfs and bolt them in place. Should do it next week (maybe the week after) so I'll put photos of how I did (or failed :LOL:) to do it. Unfortunately @Captain Nemesis...
  2. E

    Best way to cut up a metal bed base

    I'm sorry @freddiemercurystwin, here have a hug!
  3. E

    Best way to cut up a metal bed base

    Thanks for the responses everyone! I'll respond to everyone's comments & questions below: @Harry Bloomfield it's just one very large frame of metal unfortunately. I had looked at getting the upstairs window taken out but a friend new by has a similar issue to me and to get that done and...
  4. E

    Best way to cut up a metal bed base

    Hello, I've purchased a super king size bed but the base which the mattress sits on top of, but is covered buy the frame outside of it so can't be seen, is one large metal frame which cannot fit up my staircase :(, or rather than gap between the hall and stairway isn't large enough to turn it...
  5. E

    Cleaning & caring for stone / concrete driveway

    Hello, I've started using my pressure washer to clean the outside of my house and use it on the driveway and walkway I have which is a mix of concrete and stone I think (have attached a photo) but I noticed some of the stones came loose using the pressure washer. Should I stop using it? Or it...
  6. E

    Drilling into tiles

    Thanks a lot for the replies every one.
  7. E

    Drilling into tiles

    Hello, I've recently purchased a house and it lacks shelving in the ensuite so I'm putting some small glass shelves on one of the outdoor walls and in the corner of the shower itself. I just wanted to check if the approach I'm thinking of taking is correct and a few questions too. From what I...
  8. E

    Finding Bracket Rail Arms With old Connector

    Hello, Thanks you very much! It's pretty silly the amount of time I've spent trying to find these! Sorry for the delay in replying to you, I've been away.
  9. E

    Finding Bracket Rail Arms With old Connector

    Hello, I've just joined these forums and couldn't spot the best place to post this as it's a really basic question. I've got a shelving rail that was put up around twenty years ago, nothing wrong with it but I cannot find bracket arms that still fit the type of connection socket it has. I've...
  10. E

    Handing gymnast rings in garage

    Hello, Sorry about my delay in responding but my work got really busy. Thank you both for the responses, I don't think I'll be able to drill a hole through the timber as it's covered by plaster board and there's insulation behind it; although it's not impossible as the plaster board isn't...
  11. E

    Handing gymnast rings in garage

    Hello, I've recently purchased some gymnastic rings to use as part of a training regime and I'm looking to attach it to the celling in my garage and was looking for some advice on how best to do this. The rings basically have a strap that you use to tread through or around something and...
Back
Top