Search results

Waste from the sewage outlet (bottom right) is sitting on the left hand benching. It is a significant problem and accumulates there until washed away with a watering can! Appreciate it’s due to the angle and height of the outlet. Any ideas for solutions, apart from having the whole chamber...

Waste from the sewage outlet (bottom right) is sitting on the left hand benching. It is a significant problem and accumulates there until washed away with a watering can! Appreciate it’s due to the angle and height of the outlet. Any ideas for solutions, apart from having the whole chamber...

Thanks. I’ve unscrewed the nut now .

Thanks

Sorry if stupid question. How do I detach hose (see photo)? It doesn’t seem to be a push fit fitting? Thanks

Ah it turns out I wasn’t pushing it hard enough! I’ve used fairy liquid as grease, and it’s now fitted perfectly! Thanks for your help.

diameter of soil pipe

Thanks. Yeah it says 110mm on the black elbow. This was connected to the brown soil pipe. I purchased a mcalister 90 degree flexi pipe as a replacement, but that is a 110mm, not a 100mm, so it’s too small? (See new image). Thanks again

Hi, Funny smell from cloakroom toilet waste pipes, so presume a seal had deteriorated. Removed toilets and pipes, which were in 2 parts (see first image) as soil waste is offset from toilet (see third image). Wanted to replace with a flexi 90 degree pipe, so only 1 connection to soil and 1 to...

That’s great. Thank you

Hi, Replacing a utility room sink. The sink waste hole is in a different place to the previous sink. Attached image shows existing waste pipe and where the sink waste will roughly be. Wondering whether it can be connected via a flexible waste pipe? If so, is it a male and and a female thread...

Hi, Freestanding bath is gurgling when the sink tap is emptied. The pipes are not blocked. Although the noise is slightly annoying, will the gurgling cause any problems in the long run if it is not resolved? Thanks

We had a Worcester Bosch greenslave Combi (oil) fitted approx 3 months ago. A noise is radiating from within the radiators when the hot water is on, and also when the boiler is warming the small tank within the boiler. The installer cannot identify why this is happening, and hopes it might stop...

Thanks very much :)

Can I just check, I think there are flow ways at the top and bottom of each panel? Do I tap both? Thanks

Thanks for this idea, will try it tomorrow

Hi, thanks yes sorry I meant height. I believe it was installed in 2009/2010, we moved into the house in 2014. I am not sure if it worked when we moved in. Rachel

Hi, The radiator is 44cm wide by 180cm length. 3 out of 6 panels are not heating up. From left to right, the panels remaining cold are panels 2,3 and 6. I am presuming that the holes are blocked or rusted over (have bled radiator etc and nothing has worked). Is the easiest solution a new...

Hi Yesterday I had a new integrated dishwasher fitted. After they had left I noticed the top drawers on the cabinets either side were slightly sticking out. The drawers close fully but they are not flush with the cupboards which are beneath the drawers. The installers have been back today...

Just used pliers which worked. Thanks very much!