Search results

Hi is there any reason I can't trim this dpc back flush to the PVC frame? And seal it over with a plastic trim

Hi I want to replace the wooden board that was at the bottom Of the porch with a row of tiles any advice on how to do this.

Hi I Installed my own texecom last year with the the help of this forum. Today whilst decorating I had to take down one of the pir in the living I entered and enabled engineer turned power of and took it down. The alarm went of so I put the code in. But now it won't let me reset the tamper...

Hi I'm moving a double plus sockets about a metre from where it is now. It's on the ring main it has two cables connected. Both sets of wire are not long enoughwhat would be the best way to extend? Choc box Junction box Thanks

Would anyone be able to help me. I've wired in my new alarm set zones etc and now want to test before connecting the bell box. There's is one system alert on the keypad "bell tamper" would this be the reason it won't let me do a walk test. When I've tried it just says *none* I've check...

Hi, so following on from post I've re run all new cables to pir and door connects. They all come Into the panel on seperate 6 core wire. Any advice on joining all the + - together there will be 6in total and i was doubling up the wire as I'm using eol double pole. Thanks

Hi, I'm putting a new system in and when I've traced the pir and door connects back they are all connecting to one 12 core wire stuck together with tape :-0. I was gonna connect the individual zones back up and run them seperate into the panel. Any advice on best way to do this...

hi we have lead flashing that comes out from under the window by about an inch. i have resealed it on the outide and insulated the wall on the inside but the flashing is wet on the underside. i'm relucant to start the plastering until i can find the problem can anyone help?

can anyone advise how i install a vapour barrier on the pic? kingspan is going to be fixed inbetween the rafters and down as far as the the top of ground floor bay window, how do i seal the vapour barrier sheet, do i seal it at the floor board height, (dont think i could reach any further down)

I'm insulating a cold flat roof above a bay leaving a 50 mm air gap. The roof is old and isnt breathable felt there are no vents in the facia either whats the best way to add ventlation as there is no sofit? Thanks