Search results

Does any one know where i can get hold of 200cc grease cartidges from for a side lever type gun?thanks

Hi, does any one know if it is necesary to remove the head light to replace the drive belt and and tips to do this, thanks to all...

There is a obvious sound from nsf when reversing off the drive left hand down (ok rhd) on full lock hard to explain the sound more like a clunking sound ive not noticed going foward much any ideas would helpful cheers.

thanks for that !

Hi can any one give me some idea what this white mold is on the roof supports in the attic could be ? its a fine layer and wipes off almost when rubbed,is this due to poor ventilation and due to having the heating on more this year because of the cold weather,should it be treated with something...

Does any one know if you have to compress the springs to replace the struts on a Ford KA (51plate) front and rear,cheers!

I would like to make my own dumbwaiter the kind that resembles jeaves type waiter NOT the type that is a free standing unit, OR if some one has one i may be intersted in buying it , idealy i would like measurements ect any help as always much appreciated..

Thankyou the site gave me some idea it will be worth it when i go i will have the in laws aswell,thanks again..

got my traps from the usual diy at the side of the motorway, loaded with tuna 40mins later 2 black rats job done 1 in attic 1 in the broken drain,as far as im concerned a strong smelling food that will carry through the cavites will bring them out at any time just place them at side of a wall...

Any body know what the going rate is for copper im having a new system put in and will be left with some scrap, want to find out before i turn up at a dealers,thanks

thanks for your reply,i will have to investigate this further before going in i guess i remember doing a void bush on a cortina that was tuff! thanks again one and all...

word for word on advisory sheet says,nearside rear trailing arm has slight play in a pin/bush! it also says the same for the offside,hope this helps thanks,jon.

whats the best way to go about it?ive been told there about 15 quid. thanks

its a 97, and mot advisory note says slight play however i still want to replace them and brake pipes at same time whilst its off the gound it actualy says pin bush so i dont know if its simpler to put on new arm what do you think?thanks for your reply and my appoligies for not returning sooner...

Does any body know the best way on how to replace a rear trailing arm on a fiesta encore?

Hi, i need to replace a stop cock in a oap's house but ive had a look at the turn of point out side on the pavement where the meter is but i cant see where you can turn it of if you can that is, i know i could freeze the pipes with a kit (if i could find some where local that sells one)but i was...

thanks for your help everybody ive got to the point where my knowledge and courage runs out, its time to call the plumber out rather than do further damage ....jon

dont want to look thick but faq's where? thanks

its a baxi combi 80eco

gauge at past 2 put when heating on it got past the 3 well in the red of coarse but after finding out the valve bit was left open (the one you use to top up with) i closed this and the pressure dropped right down to the other way then i brought it back in the green useing this valve it settled...