Search results

Hello, I recently had a garage conversion done, the subfloor is concrete; on top of that, the builder laid plywood and stuck Karndean glue on LVT using Karndean-supplied universal adhesive. I also got gas underfloor heating installed under it. The issue is that when I turned the underfloor...

Thanks for your response. So you suggest that I need to fit the nest box replacing this?

Hi yes it's BDR91

It's not hive, it's a basic Honeywell thermostat

Moved into a new place that has a system Boiler. Can some one pls tell what are the white electrical boxes for? Need to fit in a nest thermostat on this. I think it will go in the top most White box but just wanted to make sure. Thanks

I done the way you said, but sprinkled some water from the hose afterwards. Was that a right thing to do?

Filled 1part cement and 3 part sand into the gaps of paving slabs. Made a dry mix and then sprayed with some water. Tried the wet sloppy mix but not my cup of tea as I have never done this before. Can you please tell me how long will this take to dry and do I need to spray more water after...

I agree that they are designed to run continuously but what if the fan goes faulty or the unit. There should be a switch to turn it off. Turning the mains off is not an optimal solution

Hello, Had damp issue in my buy to let and got a system put in wherein they put outlets in the bedrooms and a fan sort of thing that pulls air in the property. The work seems to have been done fine but they didn't add a switch to turn the system off, they just wired it into a socket in the...

Hi, thanks for your help. I have installed this now. One last question if you could help pls. Can i use the micro usb socket from the box to power the nest donut. ? Or any phone charger with usb or need a specific one? Thanks

Thanks for your response. Could you tell me which wire from my existing connection will go where? I understand where L and N will go. Could tell me where will the other to go from my thermostat into the nest box. About wiring the donut. I think they provide a wire to power it from the box and...

Planning to change from Salus RT500RF thermostat to nest . This is the wiring in the pic attached. Would you be able to tell me if this is a straight swap or am i missing any wires here. Thanks

Its attached to wall

Hello, I have this old cooker hood that has packed up now and would like to replace it. It is a vented japanese model (was already there when I bought the house). The issue is that the vent hole is not above the chimney as usually is the case. Can anyone please suggest how can I go about...

I believe they have gone into the mortar between the bricks..!!

I used a laser level to mark the tops...but due to messing up a hole for the middle unit had to change the hight.

You are right about the the corner units being a bit lower than the middle wall unit. The thing is that when hanging middle unit I messed up with drilling a hole for the bracket. There are bricks in the wall and my drill does not have hammer action. So drilled another set about 1 and half inch...

Thanks for your help folks. Wall and base cabinets fitted.. Waiting for doors and worktop now.

I too am about to install a few bits in my kitchen. As per some YouTube videos.. In order to hide the joiner screws.. Ppl drill a hole between the two hinge holes and join the cabinets.. Then put the hinge on.. That way these screws are hidden from sight. But do this only once you have hanged...