Search results

Thanks for replying, what is the proper way to use these terminals? Should the screw be as tight as possible? Should the cooper be twisted? Should any copper be visible?

Hi, Really hoping someone can give some advice on this during lockdown. My shower terminal block started melting today at the live section. It’s a Triton 8-7–9.5 KW shower using a 10mm cable to 50A breaker RCD, the breaker did not trip. No damage to pull cord, breaker and wire. Any advice...

What I am trying to is fit a 35mm door into a 45mm frame. The stop can’t be moved. The door frame is also not square just to make things harder, if a door frame is not square do you cut the door to match or keep the cuts on the door square?

What I think I am trying to is fit a 35mm door into a 40mm frame. The stop I dont think can be moved.

Hi, Looking for some advice, fitted a few doors in my time but never had this issue before. After cutting my door to size and putting it up to see how it fits there is a gap at the door stop (see picture). I dont remember the old door being any thinker than the new. If I move the hinge back...

Hi, Looking for some advice, fitted a few doors in my time but never had this issue before. After cutting my door to size and putting it up to see how it fits there is a gap at the door stop (see picture). I dont remember the old door being any thinker than the new. If I move the hinge back...

I don’t think that would be suitable for this?

Hi, Looking for a bit of advice. I have been installing laminate flooring in my livingroom and have become stuck on what to do when I get to my pvc door as pictured. Should I treat this as a wall and just lay up to the door, my only concern is the beading will not look right when installed as...

Would this be stong enough? its for 600*300 tiles.

Hi, I am planning on tiling my kitchen floor and plan on fixing plywood to the floorboards first. I have purchased 9mm structural ply on advice and have been reading online and I am now not sure if this will be think enough?

I dont think they will offer to brick up the lower part. I should have just put a door in there haha.

This is what was in before the new window went in. All of this was removed.

Its PVC cladding going horizontally, this has been secured to plywood.

Thanks for replying, how should this have been done? Type of insulation etc? Should there not be some type of membrane fabric stuff??

Hi, Just had new windows installed in my flat and one is causing me concern. I have attached a picture of the window in question. I think this used to be a door back in the 70s/80s,my issue is that there was lots of insulation in the bottom part before and now there is none. There is pvc...