Search results

Hi all.installing wall taps. Comes with cranked dog leg connectors. I don't need them have 2 individual 1/2 in wall plate elbow already at 150 mm spacing. So I want 1/2 inch male BSP to 3/4 inch BSP male but straight no crank. This will allow ajustment so taps are square to tiling. Does a brass...

Hi. Thinking of adding the HUD/MED panic button for the pyronix Enforcer V10 in upstairs on the landing so all my family has a way to activate alarm if they suspect unwanted visitors around our car/ property. Has anyone installed one and is it easy to program?

Daft question but a helium balloon slowly spinning in the room near a pir sensor will this cause an alarm due to movement.I can't remember if it's heat or movement these sensors detect. Ta.

Hi guys. Thinking of getting a pyronix dome camera. I have the Home control app will work with this app? Or do I need the Pro version? Cheers.

Hi. I have had the system running for a few months. It's hard wired to a deltabell E. Input at panel is set to tamper and the bell has the 2k2 resistor wire from 0v to T. It's been fine all this time I've checked the siren lid and Microswitch rear screw their ok. So now I've disabled input 33...

Hi I have the wireless bell connected which works under test mode. The hardwired siren only the strobe activates with no sound. Any ideas why it doesn't sound? Thanks

Hi. Can an expert guide me on how to wire these together? I've had some success but feel it's not quite right. When the system is armed and I simulate a break in and I cut the power and take out the battery from the panel surely the bell should sound? Can someone supply a good wiring set up...