Search results

Hi I would like to attach and program an LED to illuminate on the 64W when it is armed. It seems I can wire the LED to the Digicom outputs 1 - 8 . Forgive the silly question but where would I connect the ground? Would it be the "DC -" connection on the same connection block as the outputs ...

Dear Texperts Does anyone know if it's possible to show the alarm status on the panel display? This would be really helpful for me as when i come downstairs in the morning i would know if the panel was set, so as not to forget to unset it. I would like to wire a red LED to an output and have...

Hi After installing the smartconnect device to my elite 48w panel ( that was a test of endurance ) I put the panel generated code into the smartconnect app. I now need to register with an installer i'd from the texecom cloud website. When I go there I can't access my dashboard and it says I...

Hi DIY install (i know) I have a PIR that is sometimes detected on the walk test and sometimes not and it never seems to activate when the alarm is armed. Can I delete this zone and relearn it or do i need to do them all again ? Do I need to put the jumper to commission mode again to do...

Hi I have a Texecom 64 wireless panel that shows system alerts of "tamper on zones 1-8". tried engineer reset using the master code/ engineers code but no luck. tried omitting these zones 1-8 but that didn't work either I have only programmed zones 9-11 with 2 x pir and a 1x door contact...

Hi Does anyone know if the mains connection to the control unit can be just Neutral and Live or does it need the Earth connection too ? The Earth connection doesn't seem to go to the psu within the control panel Thanks

Hi I would like to install a new system but there are so many Texecom options, I really don't know which to choose. I would like for a small semi detached:- -use of phone app feature -wireless but option to use wired if needed - 3 x IR detectors -3 vibration detectors Anyone recommend which...