Search results

what are the sad faces for? can it be fixed?

hi guys, just after a bit of advice I have the above boiler fitted at home and up until now its been great and trouble free. so tonight while running the hot water it gets up to temp and then cuts out and then fires back up and gets up to temp and then cuts out and just keeps doing this...

Hi, Just had white oak spindles, newal posts and hand rail fitted. I need to oil/varnish but want to keep it looking as natural as possible, anyone got any suggestions on what i should use? I've also had all new internal oak doors fitted and i was hoping to use the same thing on them too...

Thanks jefoss, is this what you mean? http://www.screwfix.com/prods/41877/Drill-Bits/Tile-Drills/Diamond-Core-Drill-8mm#

Hi Guys, I've almost finished the bathroom at long last, Can anyone tell me if i need to seal these porcelain tiles? also is there something i can get for the grout on the floor that seals that to stop it from getting dirty stains? Any advise would be great. Rob

Does anyone know where I can buy some of the above? I need it for Saturday morning. Is there a particular brand? Thanks Rob

2 of the walls are fresh plaster board that i've dot and dabbed, the other walls have been skimmed over with a coat of bonding. i must say that i started worrying last night about the tiles pulling the plaster board off the walls because of the weight.

Thanks lancenotalot.

I'm sure that i read it on here and also another tiler told me. is this wrong?

can anyone recommend me a good tiler in the Thurrock Essex area? Or somone willing to travel there. Had tiler arranged to start next week but has decided he can't do my porcellin tiles. I told him that he should be using flexible adhesive and he looked like i was mad. In the end I didn't...

Hi Guys, I've just had some heating pipes put into the concrete floor, I dug the trench out and its around 50mm deep, 60mm wide and 5m long. What mix should i now use to fill the trench and cover the pipes? Many thanks Rob

I've read on here that i should wet the wall first, or should i just water some PVA down and use that? also what sort of gaps should there be between the dabs?

Hi guys, do i need to do anything to this wall before i dot and dab? Pva first? thanks Rob

Richard, thanks for your reply. If i dont have a steam cleaner can you suggest another way of getting the artex off? thanks Rob

hi guys, after a little bit of help with my bathroom ceiling. I've taken part of an old wall down and this has left a gap in the plaster where the wall met the ceiling. also there is part of the ceiling that is artex(left hand side of picture) do i need to fill this gap and go over the artex...

Thanks Richard I'll do that.