Search results

might be worth getting someone(a friend you dont have to pay) but with the knowledge you require to have a look at the drawings . loft conversions arnt rocket science but as someone has said you need the right material on site when you need them , you need to know what to do when and know...

got a problem im hoping you can help with plz when the people doing my garden ripped up the concrete path they found an old soakaway ( still used ) i quickly backfilled the hole(as no pipes where evident ) and now water from the soak way is now seeping to the surface and smelling any...

lol m8 nothing like watching someone elses pain all done thanks guys :wink:

thats great thank you , no its plastic thank you both for your time guys a slip coupling sounds just whats required :wink: the wife thinks chippy@s can do anything these days lol, ill have to screw up a little to balance things out a little gj all :D

hi , iv come to a problem that im not sure how to get round . i have an existing stack close to where i took a pipe out of the wall for my new toilet but as the existing stack has no play up or down , how do i get my new joint in to recieve the new pipe thoughts plz , im up to the...

hi all simple question im trying to lose some 15 mm pipes so need to bring the board out say 30 mm off the wall is that ok

grind the end square then try to get an edge using water to cool the blade every 10 sec or so ,if the edge of the chissel goes black repeat the process again :(

core cutting up steps and no clutch on drill maybee 15 yrs ago hurt my wrist and sent me flying off the ladder ,my advice if you have a drill without a clutch ..... pump the trigger

yep or hire 1 and get it lintels are a little unforgiving and come with steel reinforcing bars so if you lose the head of the drill most likely you hit a bar (move your hole :) if your drilling into a steel lintel you would know by the sound and the fact nothings moving

failing that the good old method of a piece of paper against the wall and drawing the pitch onto that and getting a protractor to work , a roofer would have a roofing bevel that shows you the angle in degrees on the inside edge

jusyt to prove your wiky sticky works ,i had a look round and realised i had indeed wired it wrong thanks for taking time to answer this post , personally im glad iv found you all and hopefully as a carpenter/joiner for the last 25 years maybee i have something that i can offer this forum in...

well i think so , im a chippy lol i was just using the ceiling rose junction box and just adding the two white cables from the new low v transformer onto that

ok so heres my problem ,iv replaced a normal hanging bayonet type fitting with a low voltage spotlight its on when i put the fuse back in but wont turn off ,its turning to about half the brightness when on any ideas plz