Search results

This has good reviews. They do a black granite colour. Good luck. https://amzn.eu/d/6hFTZk9

Thanks I've already thought of all of these things and the jig I have made caters for all of them . Really just need to know what tooth blade would be suitable for cutting through 15 mm of stacked card. Thanks again everyone.

Thanks. The jig I've made stops that happening .

Hi, I need to cut largish quantities of sheet card that is used to back picture mounts. It is smooth surface ,1.5 mm thick . I would like to cut say ten sheets thickness at a time into 12 X10 pieces. I have designed a jig for this but need to know what tooth blade you feel would be best for...

Thanks for your advice . Much appreciated

Thanks. Mine is an Einhell 18v. It's a great well made saw and batteries are interchangeable with my other Eiinhell tools.

Hi, I have recently purchased a cordless circular saw that I'm very happy with. I have used power tools for a long time but just had a question please. If I am cutting sheet of say 10mm board I have been setting the blade ( as I usually would do ) at about 1/4 inch deeper than the wood being...

Hello, When the weather gets better I will be working on our house's windows. Generally they are in good condition but I know there will be a few places that I might have to sand back to the bare wood. If so do I use primer just on the wood or does it matter if it overlaps/ goes onto the...

Hello, I am replacing the wall mounted 2 KW bathroom fan heater with another one that is same size and specifications. The cable to it runs from a fused switch box in the loft. Just checking what fuse should be in that switch box please. At the moment it is 5amp. Is that correct size ? Thanks

I'm not "blaming" anything. We've had the machine for about 10 years. Used to work perfectly with exactly the same plumbing setup but over the last month's is not emptying itself/ mulching properly. Have taken apart and see no blockages or damage. Perhaps mulcher has reached end of its life...

Hello, We have a Turboflush macerator at the moment that is constantly getting blocked and not emptying the chamber. I want to replace it with a Saniflow Sanibest one that is more powerful and efficient. On the the Turboflush one there is no vent pipe fitted but according to articles the...

Hi Thanks for your response. I don't want to increase pressure just hopefully use the pressure that is existing and somehow utilise it via a valve so that it changes speed. May not be possible but hope it is.

Hello, I have a pneumatic bench top press that I use to press picture hangers into frame backing board. It works really well but in an ideal world I would like to increase the speed of the piston stroke as at the moment overall down and back takes about 5 seconds. I am attaching photos of the...

Problem is the expense. I realise these things cost money though !

Hi the piston comes down fairly quickly. There wouldn't be time to remove hand. It would cause a lot of damage ! Thanks J

Hello. I'm buying a small bench top pneumatic press for my workshop It comes with a foot pedal to operate it but want to connect a two hand button control so that both buttons have to be pressed together to make sure that both hands are out of the way of danger. Is it possible to buy these for...

Any ideas ? Thanks

Hello, We have had an area of external render repaired and I will need to paint it. I have put two coats of stabilizer onto it. Normally I know that it would be necessary to put a diluted first coat of paint on first to soak into the pores but as I have stabilised it is this still necessary...

Thanks for your advice. I checked the old cable and the brown cable had been shipped short and not used.