Search results

I think the worcester repair kit includes the tool required to remove it.

oops

Has the knob fallen off leaving just the white shaft ?. If so, in an emergency, you can lock the key in place and use some pliers/grips to turn the shaft. This is only a temp measure because the shaft can become damaged when you continually use the above method. Simon

Dont put the link in, is the attanae symbol in the display flashing ? If it is then all you have to do is set up the link between receiver and transmitter. Instructions are, as already advised on the worcester website.

Increase the pressure slightly and see if your guage rises

Hi, I have a zanussi condensor dryer model TC7114w. Tried to use it last night and pushed start, got a buzzing sound then the tripswitch went on the mains fuseboard. reset trip switch and power light will come n on dryer but on pushing start, nothng happens. Any help/advice gratefully...

Have a look at the Gas to water Heat Exchanger, are their any signs of vertical lines or markings ? These are normally associated with heat distress.

Have you checked the vessel is actually conected ? They come out the box with a plug in the flow manifold .

My mate who works for a BiG company reckons you need a Powerflush !! :lol:

Hi, S.E. Means service Engineer, it just means that the boiler is due for it's annual service. When it's serviced the timescale will be reset.

I have been informed most of the pipework on my system is made of the above material. I have an open vented system fuelled by a Baxi Solo 2 boiler just doing the rads. The water is heated by a very old main water heater. I have a small leak on a soldered fitting and am unsure if I need...

Hi There I would suspect that your cold feed is blocked. Its the pipe that feeds the system from the expansion tank in your loft. do a search for blocked cold feed Regards

Could anyone please advise of a book I can purchase relating to the electrical side of heating. I am relatively newly qualified and realise my education has only just started. I have got the viper and Tolley books but these do not really cater for what I am looking for. If anyone could advise...

Cannt say i've heard of a 28 PRO ? Are you sure that's the correct model name ?

Does anyone have any idea of what Worcester's are like to work for ?> Good career move ? Many thanks

Fan control Unit, Manufacturers Part Number BOS00104. Might be the part you are looking for. GC No 385-159. Good luck

I believe the boiler is made by Ariston, The info I have is INTESA 23 TP MFFI combi Boiler.

Could you just add an exterior expansion vessel to the wall ? Would that make it easier

Problem only recently started. The valve wiring was checked today and valve found to be moving correctly. Valve also fitted round the correct way, b for bath. Apparently a rad was added in the last couple of years and this, somehow, is causing the system to back circulate. With hot water only...

Hi there I would be grateful for any assistance you could provide. Boiler is an Ideal Classic, fully pumped on a Y plan system in a bungalow. Boiler and cylinder are downstairs and pump,tanks and valve in loft. Completely renewed professionaly from a gravity system in the late 1990's. The...