Search results

Ats path fault mate.

still do unfortunately mate. Still using Com port 1, with fly lead attached.

after a weeks hols I got round to asking BT for a line check. They've said that the line is fine and 40.2 is within their acceptable operating limits. Not sure what options that leaves me now? Is there a way of testing the Com2400 to see if that is faulty? many thanks

Morning all I've checked for 50v at the NTE5 and the extension outlet that the Com2400 is plugged into. At both I have 40.2v, is this close enough to the 50v or is this likely to be the cause of the problem? thanks again for the help.

Thanks again Alarm If I get chance I'll test tomorrow and report back.

Thanks Alarm It's hard wired to the rear of the master socket using 2 and 5, then a cable run of around 6 metres to a slave socket in which the RJ11 fly lead is plugged in. I've ran a pre-made extension cable from the test socket on the master to the Com2400 previously and still had the...

Checked the Com2400 this evening and there isn't 50v across T & R. The extension cable is hard wired into the back of a master socket (built in filter) using 1,2 and 5. I tried using 2 and 5 onlyas per the instructions, however I couldn't get a dialing tone on the extension line.

cheers pal, I'll try tomorrow as I'm at work late tonight. Is there a need to power down the panel before doing this? cheers

Thanks all The line is currently wired to an extension point at the moment and connected to the panel via a RJ11 cable (BT socket to RJ11 type) into the onboard WNV port. Will I need to wire the line direct to T and R to check 50v or can this be done on the extension? many thanks for...

Thanks pal, is there anything in particular I'm looking for on the RKP when pressing 0? I seem to have a series of random letters and numbers. I can see a couple of ok's in there and a 50, does that make sense? thanks again

Got the cable - Many many thanks to Sparkymarka for sorting me out. I've powered down and fitted it this evening but unfortunately I'm still getting the ATS path fault and ATS unavailable messages. I've tried two different extension cables from the master socket and also tried extensions...

Cheers pal, that's very kind. How do I find your email address?

Ah I seem to have come across another problem! I can't find the flylead....must have put it somewhere safe.... :oops: :oops: Anyone know where you can get spares from?

I'll try it with the link and see what happens. At the moment its wired into the RJ11 connection direct to a telephone extension outlet. I've had it wired to T+R as well though but still couldn't get it to work.

Edited -double post

Hi Adrian Thanks for the prompt reply. Our providor is BT. many thanks Carl.

Hi folks I've just finished installing a Premier 24 and I've got the detection side of the panel programmed just fine. I've got a Com2400 installed (new panel so not connected the fly lead to Com1), however, whenever it's enabled I just get the ATS unavailable and ATS path fault error...

Hi folks I've just bought a 2 gang RJ45 face plate to use in our new extension (Pic attached). Only problem is I haven't got a clue how to wire it...:oops::oops: I am used to using the push down type jacks, however, this one is different and I can't figure out if you simply push the...

We are certainly pleased about the price and quality of work, done by a reputable FMB accredited builder. Quotes for fully finished ranged from £15k to £18k.

That was for - excavation and casting of footings, - standard brick and block build including cavity closers and drytherm infill, - floor slab (inc 100mm insulation), - roof construction, tiles, velux's, flashings, leadwork etc - window, door, fascia's and guttering, - slight drainage...