Search results

Hi all, Looking to install a new cctv system on a relatives house and would like some advice on whether to go ip or analog. We reckon we need 3 cameras, 1 wide angle and 2 available to zoom. I've seen some cameras that are vari focus, 2.8-12 are the fixed variety better? Initially thought...

Anyone know if it is possible to get hold of bell boxes with a bell in instead of a sounder? Searched hi & low on google, ebay etc. Old one has give up the ghost after nearly 30 years. Needs to work on an old Gardtec 816. Thanks

Hi all, I've finally managed to fix the drain on the hot water cylinder so can crack on with the new flange for the shower pump. Had no luck undoing the immersion heater cap, as the copper started to twist even with heat so I think an essex is out of the question. The top compression nut...

We have a conventional boiler with vented hot water cylinder and two tanks in the loft. All the electrical gubbins is honeywell as is the 3 position port. Trying to get my head round all the plumbing before I add a feed for the pumped shower and comparing to all the diagrams, I have an extra...

Hi, Wondering if an extra flange is necessary for a shower pump? I've seen conflicting advice and some say a feed from somewhere below the vent tee would be ok. We're remodelling the bathroom and adding a shower mixer. Hot water is from a vented cylinder with a loft tank. Mains cold is good...

Hi all, Just helped a neighbour connect his new Reson8 sounder to an ancient looking scantronic 9450. His old bell box died after he jet washed the wall after some repointing! The old sounder was connected via a small strip of connector block, a relay and small pcb with a couple of...

Hi, In our new house we've inherited a Gardtec something or other, possibly a 370 from what I've researched but 1) it's crap; I dislike the two segment LED approach and 2) it's not working properly. It's displaying 'EN' and all sorts of other rubbish when trying to set it. I do have the...

I've think I've got two unrelated problems with my 28SiII When the boiler has been used for a while, central heating or hot water, it appears to have problems restarting / firing. The pump is running, the fan starts and I can hear the ignition sparking but then it seems as if the gas valve...

WB 28CDi, wall mounted, new in Dec '99. The pressure on our WB 28CDI has, over the last few months, started to rise of its own accord. The filling key is not installed and the filling tap shut. The pressure sits at just under 3 bar with water dripping slowly from the pipe on the outside wall...