bell box

  1. A

    How to wire Texecom Odyssey grade 3 sound with Scantronic 9651

    Hello, The Texecom grade 3 sounder has a few additional wires compared to a grade 2 version. How do wire a Texecom grade 3 sounder with a Scantronic 9651? Grade 2 is very easy, it only requires 5 wires. 12v, 0v, OPT1 (Bell ), OPT2 (Strobe), TR (Tamper return) Looking at intall instructions...
  2. S

    Premier Elite 24 add new sensor without bell ringing

    Hi, I'm adding some additional sensors to my alarm system. As expected, when I remove mains from the panel then disconnect the battery, the bell rings. I can disable the bell from ringing by setting an internal jumper on the bell temporarily, but, this involves going up a ladder and the...
  3. A

    White comfort LED's bell box

    Hello. For a while, i have been looking for a bell box with bright comfort LED's. Around where i live most peoples alarm bell boxes have the standard green or red comfort LEDs, but as the box whethers they are not very visable and the LEDs can not be seen at daytime. Has anybody come across a...
  4. Matt W

    Best place to mount bell box on a bungalow?

    Hi. I have installed a few intruder alarms over the years and I have just been asked to install one for someone at a new-build bungalow, which is ground-floor only. I now have a decision to make. I can either install the bell box at ceiling height, under the eaves, at the front of the property...
  5. K

    Galaxy Dimension 96 - Two Bell Boxes Wiring Clarification

    Hi All, I have a Galaxy Dimension 96 installed and set up which is fully operational apart from the external bell boxes. The two bell boxes are both Pyronix, Different models hence only one has the ability to disable the back light. I am able to wire them to either the main panel or to a...
  6. S

    strange problem setting alarm - please help! :)

    hi everyone i've got a problem with my alarm which i've put up with for the past few years, but now it's really starting to annoy me! it's a scantronic i-on 40. i've got 2 door contacts and 3 x PIRs. the keypad is in a cupboard in the hall, which is protected by one of the PIRs. it's...
  7. M

    ADT bell box on Honeywell system

    Hi, I am about to install my alarm system to go alongside my CCTV system. I am going to install a good spec Honeywell system with autodialler and adjustable PiRs etc. However I would like to install ADT bell boxes at the front and back as they look visually more detering and nicer compared to...
  8. J

    PowerMax Complete External Siren - MCS-740

    Afternoon all, I've recently had the Visonic PowerMax Complete installed into my home, however I have noticed the LED does not pulse to indicate the external bell box/siren in on. So in the dark you can barely see there is an alarm fitted. I believe I can activate this by flicking the LED KEEP...
  9. I

    Wiring a Telecom odyssey xb bell box to a galaxy g2-20 help

    hi all I've recently purchased a galaxy g2-20 and I have a texecom odyssey xb bell box. I'm unsure of the connections. The panel has Bell + 0v T Bell pic (1003) Light pic(1004) Bell box has +12v (A) Bell (B) Tmp (C) Ov (D) Strb (S) Msw (1) Msw (2) Test (T) Tamper relay x2 Fault relay x2 Can...
Top